Laserfiche WebLink
UNDERGROUND STORAGE TANK <br />MONITORING SYSTEM CERTIFICATION FORM (Page a of B) <br />VIII. MONITORING SYSTEM AND PROGRAMMING <br />This section must be completed if a monitoring panel is used to perform leak detection monitoring. <br />Y <br />N <br />NA <br />Are the visual and audible alarms operational? <br />X❑ <br />U <br />El <br />Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, <br />tested and confirmed operational? <br />Nfunctional) <br />El <br />El <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? <br />Was monitoring system set-up reviewed to ensure proper settings? <br />)( <br />Was the monitoring panel's backup battery visually inspected, functionally tested, and confirmed operational? <br />® <br />❑ <br />❑ <br />Does the flow of fuel stop at the dispenser if a leak is detected in the under -dispenser containment? <br />0 <br />11 <br />El <br />Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically <br />disconnected? <br />Q <br />El <br />1:1 <br />Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? <br />Which sensors initiate positive shut down? (Check all that apply.) XX Sump 19 Under -Dispenser Containment <br />❑ <br />❑ <br />❑ <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) operational? <br />0 <br />For any answer of "N" above, describe in Section IX how and when these deficiencies were or will be corrected. <br />IX. COMMENTS <br />X. IN -TANK GAUGING TESTING <br />QX Check this box if tank gauging is used only for inventory control. (Do not complete this section.) <br />❑ Check this box if NO tank gauging equipment is installed. (Do not complete this section.) <br />This section must be completed ff in -tank gauging is used to perform leak detection monitoring, <br />Y <br />N <br />NA <br />Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination, including testing for <br />round faults? <br />El <br />El <br />Ll <br />Were all irAank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally <br />tested, and confirmed operational? <br />Was accuracy of system's product level readings tested? <br />❑ <br />❑ <br />0 <br />Was accuracy of system's water level readings tested? <br />❑ <br />❑ <br />E <br />Were all probes reinstalled properly? <br />El <br />L <br />❑ <br />Were all items on the equipment manufacturer's maintenance checklist completed? <br />0 <br />LT—L] <br />For any answer of "N" above, describe in Section Xf how and when these deficiencies were or will be corrected. <br />XI. COMMENTS <br />Y= Yes, N =No, NA= Not Applicable <br />