Laserfiche WebLink
1. J <br />C <br />Logic Board THIS SECTION IS ONLY FOR TECHNICIANS AND INSTALLERS! <br />LOGIC BOARD - DIP SWITCH S1 SETTINGS <br />Table 9.- Logic Board - DIP Switch S1 <br />Switch <br />Position <br />1 <br />Serial address AO <br />2 <br />Serial address Al <br />3 <br />Serial baud rate: Off = 9600, On =19200 <br />(default) (DO NOT CHANGE!) <br />4,5,6 <br />Reserved (DO NOT CHANGE!) <br />7 <br />D3, D4 LEDs: Off = normal (default) (DO <br />NOT CHANGE!), On = disabled <br />8 <br />Serial time-out: Off = enabled (default) <br />(DO NOT CHANGE!), On = disabled <br />SECTION& THIS ONLY • <br />Switch 1,2 positions: Off, Off = 1 (default), On, Off = 2, Off, <br />On = 3, On, On = 4 <br />NOTE: For standalone operation, settings must be OFF, <br />OFF. Also, for multiple pumps, master must be highest <br />address. See Appendix A. (CHANGE ONLY WHEN <br />INSTALLING MULTIPLE DRIVES!) <br />Fault Reset Switch (S2) <br />Pressing the Fault Reset switch will reset the Logic board only. <br />Jog Test Switch (S3) <br />Pressing the Jog Test switch will test power to the pump only. <br />Power LED (D1) <br />The green Power LED is on while power is applied to the unit. <br />Run LED (133) <br />When the red Run LED is flashing slowly the motor has stopped. When the LED is flashing fast the motor is <br />running. <br />Fault LED (134) <br />The number of red Fault LED flashes indicate what type of problem has occurred on the Logic board. This LED is <br />to assist technicians in Logic board diagnostics. <br />31 <br />