Laserfiche WebLink
Alarms <br />HIGH CURRENT <br />High current has been detected. The motor rotor could be locked. One or more of the phases going to the motor <br />could be open. Check the motor by checking the resistance between the terminals (see Table 8 on page 24). <br />Check all the wiring going to the motor for opens and shorts. <br />OVER VOLTAGE <br />High input voltage has been detected. Check the input voltage to make sure that it is within specifications (see <br />Table 6 on page 23). <br />LOW VOLTAGE <br />Low input voltage has been detected. Check the input voltage to make sure that it is within specifications (see <br />Table 6 on page 23). <br />OVER TEMPERATURE <br />High internal drive temperature has been detected. Check to make sure that the drive has the proper clearance on <br />all sides and that nothing is obstruction the airflow. Check to make sure that the fan is running. <br />PRESSURE SENSOR FAULT <br />Pressure transducer has faulted. Check to make sure that the pressure transducer is connected. Check the wiring <br />to the transducer. <br />SELF -TEST FAULT <br />Software has detected errors in the drive. Turn off power, check all setup switches and wiring then apply power to <br />the drive. <br />MOTOR DRIVE FAULT <br />Drive has detected a problem running the motor. Check all drive wiring (see Table 6 on page 23, Table 7 on <br />page 23, and Table 8 on page 24). <br />COMMUNICATIONS FAULT <br />Drive has detected communication errors. In standalone configuration check cable connected to J9 (see Figure 4 <br />on page 8). In multi -unit configuration, check the Slave COM connections and wiring (Figure 15 on page 25) in <br />each drive. <br />B-1 <br />