Laserfiche WebLink
D. Results of TestingfServicing <br />Software. Version Installed• IG -( � <br />c;om tete <br />ure - wing <br />checklist: <br />❑ No* <br />Is the audible alarm operational? <br />VMYes <br />❑ No <br />Is the visual alarm operational? <br />❑ No* <br />Were all sensors visuall ins , funcxionalltested, and confirmed o tional? <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) SumpfTrench Sensors; aDispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection' Yes; ❑ No. <br />❑ Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />4 N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill int s) and o ratiopro ri ? if so, at what percent of tank capacity does the alarm trigger? % <br />❑ Yes* <br />No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />list the manufacturer name and model for all replacement parts in Section E, below. <br />No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑'Product; <br />LYeand <br />❑ Water. If es, describe causes in Section E, below. <br />No* <br />Was monitoria s stem set -u reviewed to ensure ro r settin s? Attach set u rerts, if licable <br />❑ No* <br />Is all monitoring ui mento tional r manufacturer's s ifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Page 2 of 3 01/01 <br />