Laserfiche WebLink
0 <br />• <br />B-27 Compression Fitting- VAPOR <br />VULKEM <br />You do not need to worry about the B-27 fitting body <br />dropping down or falling through the bottom of the shallow <br />pan if the vapor line is threaded into the top of this fitting. If a <br />smaller line is passing through it however, it may drop down <br />and out so use caution and secure the body above the floor <br />as you loosen the nut to test it. <br />After cleaning all contact areas thoroughly, use vulkem to <br />seal between the nut and flat gasket and also to the exposed <br />threads of the body. Do not apply vulkem between the flat <br />gasket and the floor of the shallow pan or dislodge this <br />gasket. Lubrication can cause it to slip loose or pinch once <br />tightened causing a leak point. <br />FREQUENTLY ASKED QUESTIONS: <br />How do I clean up a dirty B2000 or address corrosion? <br />A) Dust, blow out and/or vacuum any dry debris from the interior. <br />B) Vacuum out any liquids, debris, gunk, etc.. <br />C) Protect any exposed test ports or threads, remove any electronic sensors. <br />D) Use Acetone to clean the surfaces so a visual inspection can be made. <br />E) Scrape the bottom and/or walls with a flat -blade tool. Re -vacuum. <br />F) Lightly sand all areas where the factory epoxy -paint is missing. <br />G) Coat any exposed steel with AmerShield, overlapping remaining factory paint. <br />How do I test / maintain the mechanical float system? <br />A) Follow steps A -D above. <br />B) Remove all mechanical float trip components. <br />When removing the float arm actuator - USE CAUTION! the sleeve that holds the <br />float arm in place may be weak or corroded. If it breaks, contact the factory for a <br />Retrofit Float Arm assembly. <br />C) Clean the float cup reservoir interiors and replace all float trip components. <br />D) Re -connect the float trip chain to the trip arm on the shear valve. <br />E) Slowly add water to each cup until it trips the shear valve. <br />F) If the water does not trip the float, check to see if it is binding. Pull up by the stem <br />to determine if it is stuck or cannot rise smoothly. Adjust components as necessary. <br />G) If it can freely move vertically but water does not trip it or rises above the top, <br />contact the factory to order a replacement. NOTE: Only round floats are available. <br />FOR MORE FAQ <br />SCAN CODE <br />SBRAVO.COM/FAQ <br />LIMITED WARRANTY <br />All containment systems sold by S. Bravo Systems, Inc. are warranted to be free from defects in material and workmanship for a period of one year from date of purchase. <br />This warranty will be limited to the repair and replacement of Bravo parts only and will exclude all claims for labor or consequential damage. No other express warranties <br />given and no affirmation of S. Bravo Systems, Inc., or its agents and/or representatives, by words or action, will constitute a warranty. IT IS EXPRESSLY AGREED THAT <br />THIS WARRANTY WILL BE IN LIEU OF ALL WARRANTIES OF FITNESS AND IN LIEU OF THE WARRANTY OF MERCHANTABILITY. <br />This warranty is void if there is any evidence of modification, abuse, negligence, or improper installation. If any fittings or components, other than S. Bravo Systems <br />approved fittings or components, are used in conjunction with any S. Bravo Systems product, the warranty pertaining to these products is immediately void. <br />4 ii -82000 -RETROFIT -KIT -14A <br />