Laserfiche WebLink
10 PHIL41TED <br /> Franklin Fueling Systems <br /> 85000-1 Seriesill Containers — Fill and Vapor <br /> Installation Instructions <br /> Introduction <br /> Phil-Tite Spill Containers (Fill and Vapor) are designed to provide easy installation and/or removal of <br /> the spill container without the need for timely excavation, cutting concrete or disassembly of <br /> secondary containment covers. Phil-Tite's drain valves drain directly into the tank, providing a fast <br /> and complete removal of excess liquid spilled during a product delivery operation while maintaining a <br /> reliable seal that is vapor and liquid tight, eliminating leaks into the environment. All Phil-Tite's Spill <br /> Containers have straight machined threads (female threads where the spill container screws onto the <br /> riser adaptor.) All Spill Containers are shipped completely assembled and CARB Phase I EVR <br /> Tested and Certified. No field assembly is required. The new 85000-1 Series Spill Container can be <br /> used as a direct replacement for a correctly installed 85000 series EVR Spill Container without cutting <br /> concrete or changing the tank riser. Note: On EVR certified systems the drop tube is installed under <br /> the fill spill container. <br /> INSTALLATION: --'P' 115 2F <br /> For New UST Installation and/or UST's being Upgraded `NVIRONMENTALHEALTH <br /> Step 1 — Determining The Correct Riser Length for Spill Container Installatid'RRMITISER CES <br /> 1. Method 1 - Cut and thread your steel tank riser to allow approximately 18 1/8" (Fill riser), <br /> and/or 18" (Vapor riser)from top of the tank riser to finish grade. This measurement assumes <br /> an M/F 4X4 Riser Adaptor will be installed. Also this measurement will allow the water tight <br /> cast iron lid to seat properly into the stainless steel sleeve when the spill container is installed. <br /> See Figure 1. <br /> 2. Method 2 -With the M/F 4X4 Riser Adaptor installed onto the Tank Riser you should have 16 <br /> 3/8" (Fill), and 161/4" (Vapor) measured from the top of the M/F 4X4 riser adapt and/or to <br /> finish grade and/or top of the diamond plate manway cover. This measurement will allow the <br /> water tight cast iron lid to seat properly into the stainless steel sleeve. See Figure 1. <br /> 3. Method 3 - Using a tape measurer, measure from top of the tank to finish grade and/or top of <br /> the manway cover. This is measurement "A". For 85000-1 Fill Spill Container subtract 18 1/8" <br /> from measurement "A" to equal XXX". "A" — 18 1/8" = xxx". For the 85000-1 vapor spill <br /> container subtract 18" from "A". The results are the length of your risers measured from the <br /> top of the tank. Cut and thread one end of your 4" riser and dry fit it into the tank bung. <br /> Measure your riser (installed into the tank bung) from top of tank to the dimension above, mark <br /> your riser. Cut this riser on the mark made above and thread this end. See Figure 1. <br /> 1 of 8 <br />