Laserfiche WebLink
Introduction <br /> This manual contains procedures to install an interstitial liquid sensor in a fiberglass tank. <br /> This manual assumes all preliminary site preparation is completed as instructed in the appropriate console site <br /> prep manual, and that field wiring from the console to the sensor junction box is in place. <br /> The Veeder-Root Interstitial Liquid Sensor for use in Fiberglass Tanks detects the presence of liquid in the <br /> interstitial space of a double-wall fiberglass tank. When liquid is detected,the sensor sends an alarm signal to <br /> console. <br /> Contractor Certification Requirements <br /> Veeder-Root requires the following minimum training certifications for contractors who will install and setup the <br /> equipment discussed in this manual: <br /> Installer Certification (Level 1): Contractors holding valid Installer Certification are approved to perform wiring <br /> and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation;wireless <br /> equipment installation;tank and line preparation; and line leak detector installation. <br /> Technician Certification (Level 2/3): Contractors holding valid Technician Certifications are approved to <br /> perform installation checkout, startup, programming and operations training,system tests,troubleshooting and <br /> servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. In addition, <br /> Contractors with the following sub-certification designations are approved to perform installation checkout,startup, <br /> programming,system tests,troubleshooting,service techniques and operations training on the designated system. <br /> • Wireless 2 <br /> • Tall Tank <br /> Warranty Registrations may only be submitted by selected distributors. <br /> Product Marking Information <br /> RELATED DOCUMENTS <br /> Documents Required to Install Equipment <br /> This intrinsically safe apparatus is only for use as part of a Veeder-Root Automatic Tank Gauging System (ATG <br /> Console with probes and sensors).To install intrinsically safe apparatus, use the specific control drawing that <br /> appears on the nameplate of the applicable associated apparatus (ATG Console): <br /> UL/cUL Control Drawing <br /> Equipment Document No. <br /> Associated Apparatus <br /> TLS-450,TLS-450PLUS/8600 331940-008 <br /> TLS-350,TLS-350R 331940-011 <br /> TLS-300 331940-013 <br /> TLS4/8601 331940-018 <br /> 1 <br />