Laserfiche WebLink
Sensor Installation Sensor Part Number <br /> 4. Locate the label on the sensor cable that corresponds to the tank size.Add the riser pipe length determined in <br /> Step 3 (measuring away from the sensor). Mark this position on the cable with one of the tie wraps provided, <br /> NOT by cutting into the cable jacket with a knife. <br /> 5. Attach a pull cord to the eyelet in the sensor and after confirming correct entry orientation (ref. Figure 3), pull <br /> the sensor through the interstitial space until the cable marked tie wrap is even with the top of the riser pipe. <br /> NOTE:All sensor types should rest at the bottom of the tank as shown in Figure 4. <br /> The switch assembly has a flat,white bottom for switch orientation during installation.When installing the sen- <br /> sor, start the sensor into the annulus with the white bottom piece facing up (Figure 3). <br /> Riser <br /> White side of <br /> sensor facing <br /> IL I <br /> up going into <br /> tank <br /> Fiberglass Tank <br /> Pull cord tied to <br /> sensor eyelet <br /> Pull Cord <br /> Figure 3. Correct Sensor Orientation Entering Top Of Tank Annulus <br /> The switch will be orientated correctly at the bottom of the tank with the white bottom piece facing down <br /> (Figure 4). <br /> Ct Riser--�' <br /> I <br /> i <br /> i <br /> i <br /> White side of sensor down I <br /> at bottom of tank annulus <br /> Figure 4. Correct Sensor Orientation At Bottom Of Tank Annulus <br /> 6. Get the installation kit. Put the cord grip bushing in the riser cap and screw the cord grip nut onto the fitting. <br /> Screw the second cord grip fitting into the junction box. <br /> 7. Pass the end of the sensor cable through the cord grip fittings in the riser cap and in the junction box. <br /> 6 <br />