Laserfiche WebLink
Installation Guide Test of the Leak Detector <br />If flow is restricted to about 3 gpm (11 Ipm) or less with the nozzle open, the leak <br />detector has not opened. Repeat Step 8a with increased running time of pump to <br />insure the purging of all air. All air must be purged from the system or the leak detector <br />will restrict flow to about 3 gpm. <br />9. Affix the enclosed decals to the dispenser dial glass on grade of gasoline upon which the leak detector is <br />being installed. Additional decals are available; call customer service at 1-800-873-3313 and request P/N <br />046-200-1. <br />10. Inspect all threaded joints to assure they are tight and not leaking. <br />U.S. Environmental Protection Agency (EPA) regulations require annual verification of operation of leak <br />detector. To assure maintenance of leak detection capability. Red Jacket requires that operation of the <br />mechanical leak detector be verified by testing upon start-up and that testing of the leak detector be <br />performed routinely, at least annually. <br />Test procedure options for mechanical leak detectors are explained in Red Jacket <br />Engineering Reports, RJ20 and RJ21. The Red Jacket Snap Tap Connectors allow the <br />FX2V/FX2DV leak detector to be tested with the FXV Snap Tap Tester as an option to <br />the above test methods. See Red Jacket literature #042-111-1 for test instructions <br />using Snap Tap Connectors. <br />11. The top cover on the Red Jacket leak detector is designed to accommodate a sealing wire which can be <br />used to discourage tampering of the unauthorized removal of leak detector. (see Figure 4). <br />FX2V / FX2DV <br />If the dispensing system (the solenoid valve and the nozzle) is opened previous to the <br />completion of the line test, the FXV Series will detect this opening as a leak and <br />restricted flow will result. Closing of the nozzle(s) for a period of time adequate to allow <br />completion of the line test will allow the leak detector to open. Once opened, full pump <br />flow can be provided. <br />Tethered cap <br />.��Sealing wh <br />I <br />�„�(provided <br />c;= - ..contractor) <br />SIDE VIEW TOP VIEW <br />Figure 4. Installing FXV in the Standard pump <br />N. <br />1/4 -inch <br />T -fitting <br />Vent tube <br />