Laserfiche WebLink
0 • <br />Results of Third Party Standard Evaluation <br />Point Sensor Liquid Contact Product Detectors <br />This form documents the performance of the cable sensor liquid contact leak detection system described below. <br />The evaluation was conducted by the equipment manufacturer or a consultant to the manufacturer according to the <br />Third Party Procedures developed according to the U.S. EPA's "Standard Test Procedure for Evaluating leak <br />Detection Methods: Liquid -Phase Out -of -Tank Product Detectors."l <br />Tank owners using this leak detection system should keep this form on file to prove compliance with the federal <br />regulations. Tank owners should check with state and local agencies to verify that this form satisfies their <br />requirements. <br />Method Description <br />Name - 1 Series UST Monitoring -/t Models 1 (§edal #Beta 0131 & TLS 350 <br />Vendor,Version with Interstitial Liguid Sensor for Fiberglass Tanks (0794390-40 1 <br />=e•= i••1t Environmental Products <br />125 Povider Forest Drive <br />(street address) <br />(city) (state) (zip) (phone) <br />Detector output type: _Qualitative <br />Detector operating principle: Electrical Conductivity Capacitance Change <br />Interface Probe Product Permeable Product Soluble Thermal Conductivity <br />Pressure Switch Magnetic Switch Other (Float Switch) <br />Detector sampling frequency: Intermittent Continuous <br />Evaluation Results <br />The detector described above was tested for its ability to detect test liquids in contact with the <br />point sensor. The following parameters were determined: <br />• Detection Accuracy - The measure of sensor response to the presence of liquids. <br />• Response Time - Amount of time the detector must be exposed to liquid before it responds. <br />• Recovery Time - Amount of time that passes before the detector returns to its baseline reading <br />after the test liquid is removed. <br />• Lower Detection Limit - The smallest liquid concentration that the detector can reliably detect. <br />• Product Activation Height - The height of liquid to cause sensor activation. <br />• Specificity - Indicates the level of response, of the detector, to several different liquids. <br />1 Carnegie Mellon Research Institute. Test Procedures for Third Party Evaluation of Leak Detection Methods: Point <br />Sensor Liguid Contact Leak Detection Systems: Final Report - November 11, 1991. <br />Liquid Contact Product Detector - Results Form Page 1 of 2 <br />