Laserfiche WebLink
Monitoring System Certification <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 17.02 <br /> Complete the follo ing checklist: <br /> Yes No* Is the audible alarm operational? <br /> s Yes No* Is the visual alarm operational? <br /> Yes No* Were all sensors visual!y inspected,functional!y tested,and confirmed operational? <br /> Yes No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> Yes No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> operational? <br /> Yes No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> N/A monitoring system detects a leak, fails to operate,or is electrically disconnected? If yes:which sensors initiate <br /> positive shut-down? (Check all that apply) N Sump/Trench Sensors; N Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? = Yes; ❑No. <br /> Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> l N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill poings)and operating ro erl ? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors,probes,or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> Yes* _ No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply)❑ <br /> Product; Water. If yes,describe causes in Section E,below. <br /> Yes ❑ No* Was monitorin system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes ❑ No* Is all monitoring a ui ment operational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 5 <br />