COMPLIANCE INFO_1993-1998 - Laserfiche WebLink

Home Browse Search

.a. clause! • v '. - ". tee, INSTALLATICN 1NSIRLK'CICN S To set the elevntion for the fibergins stamp, the optimum res Ition should -be 8" below finichat concrete or asphalt (rade. This allows a 1" overlap for steel spill collector frxne when it is elevated 1" nbove finished - concrete Fade. This elevation setting also positions the light wclght high density Ix)lyethpicne Stoll) shicid, number SC -3601 -SS to the right Position for eliminating water intrusion. L\tt the 4" fill Ittl)c riser to n length of 14$" below finished concrete grade. (Not the 1" elevntat grade) After all grades are set and tvlk-s :u'e buck filled to top of f.i.bet-gl::s stamp, Shill Collector c:m be installed. Now install the light weight high density Polyethylene stamp shield with the prober openings cut out. Then Install the nylon spill collector bucket, hand tighten agnimst "(Y' ring, if tite spill collector is used on the vapor side install vapor spill collector bucket now. (Vapor spill collector is different. It is i" shorter on the 4" riser, be sure to check this). Now the spill collector lid and frame can be installed. Lysing the c:un lock mechan.isn to fasten the lid to the frame by turning bolts sloe}. -wise until eons inter -lock with ring on frame, then tighten nplu'oximntely one turn more to tighten down ngni.nst seal. (DO this In n cross lid bittern which will apply even pressure on seal) After the ltd is properly i.nstnllcd on the frame, it can now be Positioned over sump and spill collector bnicket. It ray be to your advantage to leave off spill collector bucket "(Y' ring on this Initial installation and after concrete is poured then remove lid and install "O" rings to final installation. Be stare when lid and frame are installed that 3G" IW is at lc:ist 1" above ftniclicct concrete lz::dc and trait collector bucket Is 2" below flange in collector. If these instructions :ire followrd )'oil should have an attractive and easy installation. r ;. SUPIP Q_ T -_R LID id-MO1'Ai: For ease of lernctvnl w( hnve furnished Jack screws. Fi.ist, tiu-n all hold�cim%-n bolts (g ltcx) counterhrauoied hole to stop. Next, rcrove butlon.he:id alien screws (iso not discard) ) incest. T handle Jack saes int _-� (if "I' handles are not availnble use 5/1G"-18 Bolts) and else lid. Mlien lid Is free from collector.Lnickct t "O" ring use "T' iondle to lift 1 id from stanP• To reel:,ce lid simply lower lid ()ver '-Pill collector buckets. Ilemnve "I" handles and press lid into place, turn hcx brlte utitil I"_Sstu•c is felt, then in cross lid tightening Mattern, tighten IxtlLs to draw lid don against the Scot evenly. Plcnse re -install the button head nllen screws.