Laserfiche WebLink
CAUTION: Xerxes recommends that every site be thoroughly <br />evaluated for the potential to trap water or otherwise subject the <br />tank to a rise in the local water table. Xerxes recommends that <br />all tanks be anchored in installations in which water may enter <br />the hole. Failure to anchor may damage the tank or surrounding <br />property. <br />DEADMAN ANCHOR: <br />A deadman is a reinforced concrete beam with a total length 12 <br />inches greater than the overall length of the tank. A deadman may <br />be fabricated in multiple sections as long as the total length is not <br />decreased and each section contains at least two anchor points. <br />The width and thickness depend on the tank diameter. Refer to <br />Table 7-1 for specific dimensions. <br />TABLE 7-1 <br />TANK DIAMETER DEADMAN DIMENSIONS <br />(FT.) (W x D) (IN.) <br />SLAB WIDTH <br />(FT.) <br />4 <br />6" x 6" <br />6' <br />-- - — <br />6 <br />8 <br />12" x 12" <br />12" x 12" <br />9'6" <br />11' <br />10 <br />18" x 12" <br />13.5' <br />12 <br />36" x 8" <br />15' <br />[2LKMI <br />FIGURE 71A <br />Lay the deadmen in the excavation parallel to the tank and outside <br />of the tank "shadow." (See Figure 71 and 71A). In multiple tank <br />installations. each tank will require two deadmen. The minimum <br />spacing between tanks must be equal to twice the width of a single <br />deadman. One deadman may be used between two tanks if it is <br />doubled in width. Provide a separate anchor point for each <br />holddown strap. <br />ANCHOR SLAB: <br />An anchor slab is a reinforced concrete base. The total length of the <br />slab is 12" greater than the overall length of the tank. The minimum <br />slab thickness is 8". The width of the slab depends on the tank <br />diameter. Refer to Table 7-1 for specific dimensions. Refer to Table <br />7-2 and Figure 7-2 for anchor point dimensions. Provide a separate <br />anchor point for each holddown strap. When using a concrete base <br />slab, allow sufficient depth in the excavation for 12" of bedding <br />material below the tank (Figure 7-3). <br />---------- <br />ME POSITION STRAP -CLIP <br />I <br />ANCHORING RING DIMENSIONS <br />® <br />nil <br />l immm <br />®® <br />- <br />i-_ -- <br />— - - <br />E- <br />DIAMETER) <br />A <br />B" <br />"C" <br />D" <br />®®E <br />MIN. MAX { <br />4' <br />24" <br />18" <br />1.2 <br />27 30 8- 4"" <br />- <br />6' <br />35" <br />23" <br />13" <br />42 48 12`- '1- <br />8' <br />43" <br />31 " <br />15" <br />52" ! 58 15'- 1' <br />10' <br />57" <br />45" <br />15" <br />69" 75" ! 18'- 8�/�_ <br />12' <br />58" <br />50" <br />23" <br />87" C 93 22`- 63/i'' <br />---------- <br />ME POSITION STRAP -CLIP <br />�'Mmm <br />AT TANK TOP <br />® <br />nil <br />l immm <br />®® <br />®� <br />EN <br />ME <br />NO M®® <br />IN®®TYPICAL <br />ANCHORING <br />.. <br />®®E <br />EADMAN <br />®®®�-- �uuueuuu <br />®®®®�u®uuu®ullu® <br />®MM <br />®®®®®®INIMM <br />® <br />FIGURE 7-3 <br />