Laserfiche WebLink
v <br />6.0 Removable "screw-in"â–ºiRing lugs and cmused tank <br />openings, <br />If your fiberglass coated tank has removable, <br />'screw-in' type lifting lugs, remove lifting lug and treat <br />as an unused opening. Arry unused threaded <br />opening, shall have a metal pipe plug property doped <br />and securely installed in the opening. Rough up the <br />area around the threaded opening with sandpaper. <br />Mix resin and saturate fiberglass mat. Place the <br />saturated mat over the unused opening and apply <br />additional resin, dabbing the mat into place. <br />7.0 Lug covers for pamianent lifting lugs attachments: <br />If your fiberglass coated tank has permanently welded <br />lifting lugs, then your kit will include non-metallic lifting <br />lug covers and a tube of sealant. Install lug covers <br />over lifting lugs per the following instrudions. <br />Rough up area around the permanently affixed <br />lifting lug. Apply the sealant to the underneath side of <br />the lug cover and place lug cover over the lifting <br />lug. Push lug cover down firmly until sealant <br />protrudes out around the perimeter of the tug cover. <br />Apply any extra sealant to outside edges of the lug <br />cover -to assure a moisture tight seat. <br />Allow at least two (2) hours for sealant to cure before <br />backfilling over lug covers. Care should be exercised <br />not to hit or damage lug covers during the backtilling <br />operation. <br />8.0 Pipe connection covers: <br />Sand areas where matting is to be placed on tank and <br />piping. Saturate matting with resin and place mat <br />around pipe as shown in illustration. ° <br />Dab mat into place with additional resin if required. <br />Saturate 1' wide fiberglass strips, starting at the base <br />of the pipe, wrap the fiberglass strip around the pipe, <br />lapping the mat 1/2 its width, see illustration. <br />Note: Finishing Instructions are not complete until all <br />exposed steel surfaces on tank are sued with fibeighm <br />resin. <br />APPLY ANY EXTRA <br />SEALANT TO oUTSIOE EIDE <br />OF LUG COVER TO ASSURE <br />A MOISTURE TIGHT SEAL. <br />CLEAN PIPE <br />PRECUT MAT <br />771,Ii..1 : i:. <br />ffi <br />FjU owa-a FWAwS kowwwos IW aw C&SM Tai 0446 "S <br />g fZ. <br />