COMPLIANCE INFO_2010-2012 - Laserfiche WebLink

Home Browse Search

Monitoring System Certification-Page 2 of 3 Site Address: 6633 Pacific Ave Date of Testing/Servicing: 12/13/12 D. Results of Testing/Servicing Software Version Installed 328.03 Com lete the following checklist: ® Yes ❑ No* Is the audible alarm operational? ® Yes ❑ No* Is the visual alarm operational? ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ® Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem) ❑ N/A operational? ❑ Yes ❑ No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment ® N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut-down due to leaks and sensor failure/disconnection? O Yes ❑ No © Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no ® N/A mechanical overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fillpoint(s)and operating properly.? If so,at what percent of tank capacity does the alarm trigger? 0 % ❑ Yes* 11 No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E,below. ❑ Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product;❑ Water. If yes,describe causes in Section E,below. a Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settfn s? Attach set-yreports,i a licable. a Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? *In Section E below,describe how and when these deficiencies were or will be corrected. E. Comments: Monitor Certification performed for Permit Final due to replacement of 87-1 Fill Sump Sensor {L.8}.