Laserfiche WebLink
I <br /> Replacing the ECPU Board Restoring System Setup Data ECPU Board <br /> Restoring System Setup Data - ECPU Board <br /> 1. Restore AC power to the console.The console front panel display will cycle through the following screens: <br /> CLEARING ALL RAM : <br /> SYSTEM COLD START <br /> SYSTEM SELF TEST - <br /> SYSTEM STARTUP COMPLETE <br /> Wait until the printer prints: <br /> *** SYSTEM RESET *** <br /> NM DD, YYYY HH s MM .71X3 <br /> and the front panel display reads: <br /> Al <br /> MMM DD,YYYY HH:MM:SSXM .., <br /> RESTORE SETUP DATA: NO <br /> 2. Push the Battery Backup switch,(SW1) up to the ON position. <br /> 3. Press the CHANGE key: <br /> MMM DD,YYYY HH:MM:SS XM - - — <br /> RESTORE SETUP DATA:YES <br /> 4. Press the ENTER key: <br /> RESTORE SETUP DATA: YES <br /> PRESS<STEP>TO CONTINUE <br /> 5. Press the STEP key and the printer prints: -- <br /> ARCHIVE UTILITY <br /> RESTORE SETUP DATA <br /> START TIME: <br /> MMM DD, YYYY ElE:MM XK <br /> The console begins the restoring process of copying the system setup data you archived ln'the E2 chip into <br /> the new ECPU board's RAM.Depending on how complicated your system setup.data is,this procedure could <br /> last for several minutes.When the restoring process is complete the printer prints out: <br /> 11 <br />