Laserfiche WebLink
• <br />• <br />Page of <br />7. UNDER -DISPENSER CONTAINMENT (UDC) TESTING <br />Test Method Developed By: ❑ UDC Manufacturer X Industry Standard ❑ Professional Engineer <br />❑ Other (Spec) <br />Test Method Uses: ❑ Pressure ❑ Vacuum X Hydrostatic <br />❑ Other (Spec) <br />Measuring Equipment Used for Testing: INCON TS -STS V2.1 <br />UDC # Disp 01 UDC # UDC # <br />UDC Manufacturer: Total Containment <br />UDC Material: <br />Plastic <br />UDC Depth: <br />30" <br />Height from UDC Bottom to <br />8" <br />Highest Piping Penetration: <br />Height from UDC Bottom to <br />12" <br />Lowest Electrical Penetration: <br />Condition of UDC prior to <br />Dry / Dirty <br />testing: <br />Portion of UDC Tested. <br />2" Past highest piping <br />penetration <br />Does turbine shut down when <br />UDC sensor detects either <br />Yes <br />product or water? <br />Turbine shutdown response <br />4 Sec. <br />time. <br />Is system programmed for fail- <br />Yes <br />safe shutdown? <br />Was fail-safe verified to be <br />Yes <br />operational? <br />Wait time between applying <br />15 Min <br />pressure/vacuum/water and <br />starting test: <br />Test Start Time: <br />10:27 / 10:43 <br />Initial Reading (RI): <br />4.796 /4.796 <br />Test End Time: <br />10:42 /10:58 <br />Final Reading (RF): <br />4.796 / 4.796 <br />Test Duration: <br />15 Min. <br />Change in Reading (RF -RI): <br />.000/.000 <br />Pass/Fail Threshold: <br />.002 <br />Test Result: <br />Pass <br />Was Sensor removed for <br />Yes <br />testing? <br />Was Sensor properly replaced <br />Yes <br />after testing? <br />Comments — (include information on repairs made to facilitate a passing test and indicate whether a <br />permit was obtained for the repairs) <br />All hydrostatic test performed twice to insure testing results <br />Note: Hydrostatic testing of the UDC should, at a minimum, provide for a liquid level that tests to <br />the highest point of piping projection into the containment vessel. <br />nnTTO'r 9 T L-11AA1 <br />