Laserfiche WebLink
0 <br />ENVIRONMENTAL HEALTH DEPARTMENT <br />P°UIN <br />a ?� Donna K. Heran, R.E.H.S. <br />Director <br />Al Olsen, R.E.H.S. <br />c .:P Program Manager <br />FORS Laurie A. Cotulla, R.E.H.S. <br />Program Manager <br />December 9, 2002 <br />SAN JOAQUIN COUNTY <br />304 East Weber Avenue, Third Floor <br />Stockton, California 95202-2708 <br />Telephone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />General Environmental Management Services <br />PO Box 8282 <br />Pittsburg, CA <br />RE: California Highway Patrol <br />3330 N. Ad Art Road <br />Unit Supervisors <br />Carl Borgman, R.E.H.S. <br />Mike Huggins, R.E.H.S., R.D.I. <br />Douglas W. Wilson, R.E.H.S. <br />Margaret Lagorio, R.E.H.S. <br />Robert McClellon, R.E.H.S. <br />Mark Barcellos, R.E.H.S. <br />Your application for permit to install a new underground storage tank system at the above <br />location has been approved with the following conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution Control District <br />for applicable permits. <br />2. Any changes shall be submitted to EHD for approval prior to commencing work. All new <br />submittals supercede the previous ones. <br />3. Contractor training records for the Total Containment and AO Smith piping must be <br />submitted prior to commencing work. <br />4. Both primary and secondary pipes shall bear a UL label. <br />5. All pipe fittings and connections shall bear a UL label. <br />6. All monitoring systems shall be listed on the LG113-16. <br />7. All testing shall be in compliance with manufacturer's instruction, section 2635 and section <br />2636 of California Code of Regulations (CCR) <br />8. Automatic pump shutdown must satisfy CCR 2636(8). <br />9. All piping must slope to a containment sump with an audible/visual alarm. <br />10. All equipment in contact with backfill must be corrosion protected <br />11. Overfill prevention must satisfy CCR 2635(b)(2). <br />12. An accurate and drawn -to scale -as -built plan must be submitted to EHD prior to the final <br />inspection. <br />13. A complete monitoring and response plan must be submitted prior to the final inspection. <br />14. All lines and tanks shall be tested for tightness, in accordance to manufacturer's guidelines <br />by a licensed tank tester and results received prior to the final inspection. <br />15. Contact Dennis Catanyag, REHS at (209) 468-3459 for inspections. See inspection checklist <br />for the required inspections. <br />16. All inspection appointments must be scheduled 48 hours in advance. <br />17. Permit expires December 31, 2002. Note: If an extension to the expiration date is required a <br />request must be received in writing to this office prior to the expiration date. <br />r... -'wank yo <br />tenn�at�nya4EHS <br />Registered Environmental Health Specialist <br />