Laserfiche WebLink
Position-Sensitive Sensor installation Manual Sensor Setup Notes <br /> SENSOR WIRING <br /> 1. Screw the connector on the end of the sensor cable onto the plug in the top of the sensor housing. <br /> 2. Install the Cord Grip supplied with the wiring kit in the pan/sump junction box in which the field wiring from the <br /> console terminates. <br /> 3. Coil up the excess cable and tie wrap it out of the way. Feed the two-lead end of the sensor cable through the cord <br /> grip in the junction box.Tighten the cord grip nut to ensure a watertight seal at the cable entry. <br /> 4. Using wire nuts,connect the two-wire cable to the field Aires from the console as shown in Figure 4. <br /> To Black <br /> Interstitial i i <br /> Sensor I I Seal-off i i From <br /> Interface i i Sensor <br /> Module i i White <br /> _�_'1/2"rigid/e <br /> conduit <br /> Epoxy sealed connections in a <br /> s nS.m\ddps(,c ps weatherproof junction box <br /> Figure 4. Sensor Wiring Connections(No Polarity) <br /> 5. Seal wire nuts with epoxy sealant following the instructions in Figure 5. <br /> Ct LMON:Epoxy sealant is irritating to eyes,respiratory system,and skin.Can cause allergic skin reaction.Con- <br /> tains:epoxy resin and Cycloaliphatic epoxycarboxylate.Precautions:Wear suitable protective clothing,gloves,eye, <br /> and face protection. Use only in well ventilated areas.Wash thoroughly before eating,drinking,or smoking. <br /> G. Push the epoxy sealed bag into the junction box.Replace and tighten the junction box cover. <br /> Sensor Setup Notes <br /> Setting up the console to monitor Position-Sensitive Sensors is done under the Liquid Sensor setup function.For the <br /> LIQUID SENSOR TYPE entry,select TRI-STATE(SINGLE FLOAT).Make additional sensor setup selections as <br /> required. <br /> J <br />