COMPLIANCE INFO_1999-2008 - Laserfiche WebLink

Home Browse Search

f+ STE Foos •,04 13:37 FAX 916371527 TITAN PME WSAC i" Phil'-ite Enc■ prises Phil -rite $5100-F and 85101-19V Series SPill Collectors INSTALLATION INSTRUCTIONS Introduction r Phil -rite Enterprises Spill Containers (Fill and Vapor) are designed to pro��de easy, installation and/or removal of the spill bucket without the need for timely excavation, cutting concrete or disassembly of secondary containment covers. Phil-Tite's drain valves drain directly into the tank, providing a fast and complete removal of excess liquid spilled during a product delivery operation while maintaining a reliable seal that is vapor and liquid tight, eliminating leaks into the environment. All Phil-Tite's Spill Collectors have straight machined threads (female threads where the spill bucket screws onto the riser adaptor.) All SpillCollectors No assehipped mbly is required.) Note:ed EVR and CARS Phase I EVR Tested and Certified certified systems the drop tube is installed under the fill spill bucket. INSTALLATION: faire erg - For new or upgraded UST's. 1. Method 1 - Cut and thread your steel tank riser to allow approximately 171/4" (Fill) 17" (Vapor) from top of the M/F 4X4 adaptor to finish grade or top of the diamond plate manway cover. This measurement will achieve 5 gallons capacity. Sere Figure 1. Ensure there is adequate clearance to provide at least 4 7/16" to 4 34" inches between the top of the Spill ontainer and the top of the stainless steel sleeve once final installation is complete. Use a tape measures � ify.ch For 0a F and installation use the Styro-foarh spacer that is shipped 85101 -NV Spill For 5 gallon nththis sr Correctly e� et the depth of the blackpit bucket below de ie stainless steel sleeve. Figure 2. 2. e h - Using a tape measure, measure from top of the tank to fi��+sP grade or top of the manway cover. This is measurement "A". For Fill Spill Collectors (85100-F) subtract 18 518" from measurement "A" to equal l omI"A" The18" - xxx". For vapor spill collectors (85101 -NV) �lkbt,. results is the length of your riser measured from the top of the tank. Cut and thread one end of your 4" riser and dry fit it into the tank bung. Measure your riser (installed into the tank bung) from top of tank to the dimension above, mark your riser. Cut this riser on the mark made above and thread this end. See Figure 1. Stec) 2 --Dry Fit All QpMQQ1l&W1 all Dry fit your riser to verify your measurements. After you have dacryfitted ved fuel components and are satisfied with your measurements, appy pp resistant, non hardening thread sealant (pipe dope) to the NPT threads on both ends of the tank risers. Page 1 of 6