COMPLIANCE INFO_2000-2007 - Laserfiche WebLink

Home Browse Search

MONIT(f ING SYSTEM CERTIFf ATION CERTIFICATION /TEST DATE: August 14, 2006 Al. FACILITY A2. OWNER Name Miramar Enterprises Name Angle Enterprises Address 1605 S. EI Dorado Street, Stockton, CA 95206 Address 35584 Conavan Lane, Fremont, CA 94536 Phone # 209-939-1906 Phone # 510-552-4822 Contact Balaji Angle Contact Balaji Angle D. RESULTS OF TESTING / SERVICING Make / Model of Monitoring System: Gilbarco EMC Software Version Installed: 8.01 Complete the following checklist: ■ Yes ❑ No* Is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? ■ Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modems) ■ N/A operational? ■ Yes ❑ No * For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ❑ Dispenser Containment Sensors. positiveE Yes El No* Did you confirm ElYes ElNo * For tank sy t ms that utilize shut -down i monitoring system as the primary tank overfill device (i.e. no ze the n n ■ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill points) and operating properly? If so, at what percent of tank capacity does the alarm trigger? ■ Yes * ❑ No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ■ Yes * ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ■ Water. If yes, describe causes in Section E, below. r- ■ Yes ❑ No* Was monitoring system set-up reviewed to insure proper settings? Attach set-up reports, if applicable. ■ Yes ElNo- Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Replaced power lamp on the EMC. Minor condensation in the 91 STP sump. 2006 Walton Engineenng, Inc. Page 2 of 3