Laserfiche WebLink
E <br />JoaquinSan • <br />Environmental Department <br />December 9, 2008 <br />. I i <br />Phone:1• 468-3420 <br />1') 464-0138 <br />Fahy Construction Co. <br />411 N. Buchanan Cir. #2 <br />Pacheco, CA 94553 SENT VIA MAIL <br />Re: Miramar Enterprises, 1605 S. El Dorado St., Stockton CA <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />The permit (SR0056006) for the enhanced vapor recovery phase II upgrade on the underground <br />storage tank system (UST) at the above referenced site has been approved with the following <br />conditions: <br />Conditions of approval: <br />1. Contact the local fire department, city building department and the San Joaquin Valley <br />Air Pollution Control District for any applicable permits. <br />2. Any changes shall be submitted to the San Joaquin County Environmental Health <br />Department (EHD) for approval prior to commencing work. All new addenda supercede <br />the previous ones. <br />3. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />4. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all of the <br />following: <br />a. One of several permissible valid, current contractor's licenses issued by the <br />Contractors State License Board (may be issued to the installation company), and <br />b. All valid, current California UST certificates issued by the International Code <br />Council (ICC), that are applicable to the work being performed, and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced; <br />and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />5. Before the alarm history is cleared, a current printout must be created and available for <br />EHD inspection. Inspection may occur during the functionality test. <br />