Laserfiche WebLink
1 0 R6CEIVED <br />SWRCB, January 2002 AR 0 8 2017 Page 2 of 2 <br />7. UNDER -DISPENSER CONTAINMENT UD <br />Test Method Developed By: ❑ UDC Manufacturer ® Industry Stan-;;(fOffiffrigineer <br />❑ Other (Spec) DE <br />Test Method Used: ❑ Pressure ❑ Vacuum 'A Hydrostatic <br />❑ Other (Spec) <br />Test Equipment Used: INCON TS -STS Equipment Resolution: +/- 0.002" <br />UDC # Di s . 14/15 UDC # UDC # UDC # <br />UDC Manufacturer: Unknown <br />UDC Material: Fiber lass <br />UDC Depth: 30" <br />Height from UDC Bottom to Top 13" <br />of Highest Piping Penetration: <br />Height from UDC Bottom to N/A - Not In UDC <br />Lowest Electrical Penetration: <br />Condition of UDC prior to D <br />testing: <br />Dry <br />Portion of UDC Tested' 17" <br />Does turbine shut down when <br />UDC sensor detects liquid (both ❑ Yes []No X NA ❑ Yes ❑ No A NA ❑ Yes ❑ No ® NA ❑ Yes ❑ No X NA <br />product and water)?* <br />Turbine shutdown response time N/A <br />Is system programmed for fail- ❑ Yes ❑No fA NA ❑ Yes ❑ No ® NA ❑ Yes ❑ No X NA ❑ Yes ❑ No ® NA <br />safe shutdown?* <br />Was fail-safe verified to be ❑ Yes ❑ No NINA ❑ Yes ❑ No ® NA ❑ Yes ❑ No ® NA ❑ Yes !❑ No X NA <br />operational?* <br />Wait time between applying <br />pressure/vacuum/water and 15min <br />starting test <br />Test Start Time: 10:39am <br />Initial Reading Rt): 5.3723" <br />Test End Time: 10:54am <br />Final Reading (RF): 5.3723" <br />Test Duration: 15min <br />Change in Reading (RF -RI): 0.000" <br />Pass/Fail Threshold or Criteria: +/- 0.002" <br />Test Result: ® Pass ❑ Fail 0 Pass D Fail ❑ Pass ❑ Fail ❑ Pass D Fail <br />Was sensor removed for testing? 9 Yes ❑No ❑ NA ❑ Yes ❑ No ® NA ❑ Yes ❑ No X NA ❑ Yes ❑ No ® NA <br />Was sensor properly replaced and ® Yes ❑No ❑ NA ❑ Yes ❑ No X NA ❑ Yes ❑ No X NA -]Yes ',]No X NA <br />verified functional after testin ? <br />Comments — (include information on repairs made prior to testing, and recommended follow-up for failed tests) <br />Vapor piping chase secondary boot replaced, & band clamps tightened on all test boots before testing UDC. <br />' If the entire depth of the UDC is not tested, specify how much was tested. If the answer to any of the questions indicated with an <br />asterisk (*) is "NO" or "IATA", the entire UDC must be tested. (See SWRCB LG -160) <br />