Laserfiche WebLink
CPT Controller Manual dl RE®,A <br /> CKET <br /> Step 8: Wrap the open end of the resin pouch with electrical tape <br /> or wire tie (not included), and leave the pouch in a wire-up position <br /> until the resin gels. <br /> DO NOTturn the resin pouch upside down until it has <br /> au ion r hardened. <br /> Sealing Wire Connections in the Optional Connector Board and <br /> Housing <br /> The following steps describe the task of sealing wire connections in <br /> the optional connector board and housing. <br /> Green Wir Tie From Pressure <br /> Transducer <br /> Red <br /> Threaded Cap <br /> Housin Connector Board <br /> Black <br /> Threaded Cap Wire Tie <br /> To the CPT <br /> Controller Compression Fitting <br /> FIGURE 3.13 OPTIONAL CONNECTOR BOARD AND HOUSING <br /> Make sure that the power is turned off until the <br /> C UO connector board and housing are installed. <br /> Step 1: Remove the threaded end caps (not the compression <br /> fitting) from the housing. <br /> Step 2: Feed the cables through the compression fittings in each <br /> threaded cap, pulling enough cable through one threaded cap to <br /> accommodate sliding the housing over it. <br /> Step 3: Strip the insulation on the conductors back about '/$inch. <br /> Step 4: Connect the conductors as follows: <br /> 0 red with red <br /> 0 green with green <br /> 0 black with black <br /> ARE260-240 Rev.A ♦ 6/97 3-17 Chapter 3:Installation <br />