Laserfiche WebLink
CPT Controller Manualto *_"�REDJACKET <br /> Step 1: Attach and secure the Tandem interface cable between the <br /> RS-232 DB9 connectors on both CPT Processor boards. <br /> d <br /> 1 a4+ <br /> ast� <br /> ar y v.r <br /> FIGURE 3.14 ATTACHING THE RS-232 CABLE <br /> Step 2: On both controllers, attach the Input wires as described in <br /> the section called "Running and Attaching the Input Power." <br /> Step 3: Attach the dispense-enable signal wires to the terminals on <br /> the master controller's Inverter board as described in "Running and <br /> Attaching the Dispenser Input." <br /> Notice/ For tandem operation,the dispense-enable wires must <br /> be connected to the master controller. <br /> Step 4: On both controllers, attach the Output wires as described in <br /> the section called "Running and Attaching the Output Power." <br /> Step 5: Install the transducer and I.S. barrier by following the <br /> instructions in the appropriate section listed in the "Installing the <br /> Intrinsic Safety Barrier and Pressure Transducer." <br /> Njo ct e/ For tandem operation,the transducer wires must be <br /> connected to the master controller. <br /> ARE260.240 Rev.A ♦ 6/97 3-19 Chapter 3: Installation <br />