Laserfiche WebLink
U <br /> AL <br /> Attached Collar ( ) OK Secondary Contained <br /> This fiberglass attached collar, without flange, can Service Fittings <br /> be used to surround the fitting(s)or manway.The <br /> cSecondary contained service fittings, typically a <br /> collar can be used with attached collar risers (as <br /> shown below in I&J). I.D.'s can be 42'or 48 4"NPT within a b"NPT, allow the tank to be <br /> Strap locations can be affected. connected to a <br /> secondary <br /> contained <br /> piping <br /> system. <br /> L <br /> Grommet Kits <br /> When high water conditions <br /> do not exist, electrical con- <br /> Attached Collar Riser (ACR) nections and secondary piping <br /> can be field installed on an <br /> This fiberglass attached attached collar riser using <br /> collar riser is intended for optional rubber grommets. <br /> use with a 42"or 48"dia- <br /> meter attached collar. Grommets are available in the following sizes: <br /> (This is sold separately. <br /> See H.) Riser body is 42" 3/4"for 3/4"O.D. electrical conduit <br /> or 48"I.D.,with a flat top I"for 1"0.D. electrical conduit <br /> and a 22"or 32"diameter 2", 3"and 4"for 2', 3"&4"0.D. FRP pipe <br /> friction fit cover within top. <br /> This riser provides an en- Each kit includes six(6)grommets. <br /> closure for a submersible <br /> pump and also provides <br /> a termination point for <br /> double wall piping systems. t� Fiberglass Bulkhead <br /> The bonding of riser to Coupling Kit <br /> collar is to be done by the <br /> contractor. (Adhesive kits <br /> are included.) The 3"FRP coupling is a two-piece fitting that is <br /> bonded to the attached <br /> collar riser by the contractor. ,- <br /> Jaterti t The male and female sections; <br /> g of the FRP coupling are S <br /> Attached Collar Riser (ACRWT) threaded together to hold <br /> the fitting in place while the <br /> This fiberglass watertight adhesive cures. Each kit in- <br /> cludes one 3" FRP coupling, <br /> attached collar riser is in r <br /> tended for use with a 42" adhesive and instructions. <br /> or 48"diameter attached <br /> collar. (This is sold separately. Electrical Bulkhead <br /> See H.)The riser body is <br /> 42"or 48"I.D.with a ) Coupling Kit <br /> 24"by 30"oval opening. <br /> This provides an en- <br /> closure for a submersible The I"electrical coupling kit is a three-piece fitting <br /> pump and also provides a which is bonded to the <br /> termination point for double- attached collar riser by the <br /> wall piping systems. The contractor. The male and <br /> bonding of the riser to the female sections are threaded <br /> ;• together to hold the electrical <br /> collar and the top to the riser ,�",'__ , coupling in place while the , <br /> is done by the contractor. __ <br /> (Adhesive kits are included.) adhesive cures. Each kit in <br /> cludes four 1" steel couplings, <br /> adhesive and instructions. <br /> 12 <br />