COMPLIANCE INFO_1997-2002 - Laserfiche WebLink

Home Browse Search

g8k ,,��37 AOL Flexible Entry Boots a Environ offers a complete line of environmentally safe Part No. Type Use Nominal Size Boot ID Hole Saw Size sump entry seals in sizes to seal standard electrical a ; conduit, rigid pipe and flexible pipe. Environ offers u �1�0.2wi� Flexible Entry Boots in both "Studded Ring' and FEB-3075 Studded Ring Conduit 3/4" 1.05" 2-3/8" "Compression Ring"configurations. Both of these type � � 1/4 entry boots are made of materials suitable for underground burial and exposure to fuels. FEB-3100 Studded Ring Conduit 1" 1.32" 2-3/8' MW=- 4 FEB-0150 Expansion Ring Pipe 1-1/2" 1.81" 4-1/4' FEB 0 Expansion Ring Pipe 2" 2.37' 5-1/2" FEB 0300 Expansion Ring Pipe 3- 3.50' 5-1/2* FEB-7400 Studded Ring Pipe 4" 4.50' 5-1/2" i Studded Ring Flexible Entry Boots Expansion Ring Flexible Entry Boots This style of Entry Soot mounts to a sump wall by means of stainless This style of Flexible Entry Boot mounts to a sump wall by means of a nylon steel studs,a compression ring and nut fasteners and seals to the pipe or expansion ring and to the pipe or conduit using a band damp. To install this conduit by using a band damp. To install this type of boot,it is necessary to type of boot it is only necessary to drill the boot opening using the first drill a series of smaller stud holes around the opening using a templet appropriate size hole saw. The smaller stud holes are not required.This and then the boot opening using the appropriate size hole saw. Detailed boot uses an internal expansion ring to create the pressure seal. Detailed Installation instructions are packaged with the boots. installation instructions are packaged with the boots. Available soon. f,x A `x KY Entry Boot Flexibility Angled Entries Round Surface Installations All entry boots are designed to provide universal Flexible Entry Boots are designed to permit up to Flexible Entry Boots may be installed on round flexibility for the pipe or conduit proving up and a 30' angle of flexibility for pipe and conduit surfaces which have a radius diameter greater down,side to side,back to front movement as entries. Angles greater than 30'could prevent than 30'(750mm). The installation procedures well as angled pipe entries. This flexibility is the boot from sealing around the pipe or conduit. are the same as described above except that the important for aligning pipe connections or as a If angled entries are required, make sure the bolt holes should be made slightly larger after stress relief for the pipe during backfilling and boot opening in the wall has a sanded edge so initial drilling. Only'Studded Ring"entry boots ground movement. as not to damage the entry boot. should be used on round surfaces. 0 h O v O O/ CO) ,/