Laserfiche WebLink
Installation Guide Warnings <br /> Warnings <br /> LOW CURRENT <br /> The current going to the motor has been less than 1 amp for more than 5 seconds. Check the entire system <br /> for proper operation and wiring. <br /> DRY RUN <br /> the drive has detected a dry run. Please check product level in the tank. If fuel levels are sufficient check the <br /> wiring going to the motor(see Table 14). <br /> LONG RUN <br /> The drive has detected a handle request continuously for more than 2 hours without product being dispensed. <br /> Check the wiring and operation of the handle signal from the dispensers. If it is a true dispense of that duration <br /> and flow requirement,disable the Long Handle Warning (see Table 12). <br /> COM WARNING <br /> The master VSFC unit has lost communications with another VSFC unit.Check all the communication wires <br /> and power to all drives and then reset the master drive(J6,Table 11, Figure 8,J9). <br /> EEPROM WARNING <br /> The VSFC drive had a problem reading from the EEPROM. Reset the master VSFC drive. If the warning <br /> persists than the drive has a problem with the EEPROM.The drive will still operate in this state; it will not be <br /> able to save any warning or alarm histories. <br /> SETUP WARNING <br /> The VSFC drive detected a setup problem.Turn off power,check all setup switches and wiring then re-power <br /> the drive. <br /> 27 <br />