COMPLIANCE INFO_2016-2018 - Laserfiche WebLink

Home Browse Search

F. In -Tank Gauging / SIR Equipment: W Check this box if tank gauging is used only for inventory control. Check this box if no tank gauging or SIR equipment is installed. This section must be completed if in -tank gauging equipment is used to perform leak detection monitoring. Complete the following checklist: 0, Yes No* Has all input wiring been inspected for proper entry and termination, including testing for ground faults? Yes No* Were all tank gauging probes visually inspected for damage and residue buildup? Yes No* Was accuracy of system product level readings tested? Yes No* Was accuracy of system water level readings tested? +` Yes No* ere all probes reinstalled properly? IT, Yes r Yes r No* ere all items on the equipment manufacturer's maintenance checklist complete . * In the Section H, below, describe how and when these deficiencies were or will be corrected. G. Line Leak Detectors (LLD): r Check this box if LLDs are not installed. Complete the following checklist: MAR 13 2097 ro Yes r No* For equipment start-up or annual equipment certification was a leak simulated to verify LLD c all that apply) Simulated leak rate: F3 g.p.h.; 0.1 g.p.h; 0.2 g.p.h. N/A •' Yes r No* Were all LLDs confirmed operational and accurate within regulatory requirements? e Yes r No* Was the testing apparatus properly calibrated? IT, Yes No* For mechanical LLDs, does the LLD restrict product flow if it detects a leak? N/A :.: Yes No* For electronic LLDs, does the turbine automatically shut off if the LLD detects a leak? N/A Yes No* For electronic LLDs that are programmed for positive shut down, does the turbine automatically shut off if any portion of the monitoring system is disabled or disconnected? N/A Yes r No* For electronic LLDs that are programmed for positive shut down, does the turbine automatically shut off if any portion of the monitoring system malfunctions or fails a test? ,' N/A Yes r No* For electronic LLDs, have all accessible wiring connections been visually inspected? ro N/A *' Yes No* 1were all items on the equipment manufacturer's maintenance checklist completed? * In the Section H, below, describe how and when these deficiencies were or will be corrected. Page 3 of 3 12/07