Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 328.03 <br />Complete the following checklist: <br />rw Yes <br />r No* <br />Is the audible alarm operational? <br />11791 Yes <br />r No* <br />Is the visual alarm operational? <br />f+ Yes <br />r No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />1170 Yes <br />r No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with <br />heir proper operation? <br />Yes <br />r No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />N/A <br />r# Yes <br />r No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring <br />r N/A <br />system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check <br />all that apply) P Sump/Trench Sensors; NO Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? IT# Yes; r No <br />r Yes <br />r No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill <br />prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If <br />N/A <br />o at what percent of tank capacity does the alarm trigger? % <br />C Yes* <br />r No <br />Nas any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />anufacturer name and model for all replacement parts in Section E below. <br />Yes* <br />G No <br />as liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />Product; r Water. If yes, describe causes in Section E below. <br />* Yes <br />Ir No* <br />lWas monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />r* Yes <br />r No* <br />s all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />Monitoring System Certification Page 2 of 3 12/07 <br />