COMPLIANCE INFO_2011-2018 - Laserfiche WebLink

Home Browse Search

Replacing the ECPU Board lnstaping the ECPU Board Ci Rest bottom of tool on socket Rush down wit thumb to hold toot an socket 4 Continuing to apply pressure with fingers. gently lift the tool straight up until the chip pins are clear of the socket xuinue to pun up at fingers until 1p Is lifted up sinst bottom tool. Figure 4. Removing the EEPROM Chip from the ECPU Board --jj ------L----- U -----!a.--. ---1,7Tthm'MnTnm M MI'T nM 'MM '�J u' ------------ U13 i----! Notch w � I (Painted r r on board) 17 indented f r U32 F - 1 i 1 1 , samlt3rct9 r :, (Onch!p) ---- t r U12 t , I r -_--� Y2 Check to see that chip pins are aligned and not bent. Orient clip so that the small indented semicircle on the top of the chip is on the same end as the small notch painted on the board above the socket (in this example on the top) . Carefully align the chip pins over the socket how and gently push the cls down until all the pins are in the socket holes. Then putt dawn frallyy and evenly on the chip lentil it is down against the socket. Check to see that each of the pins is in is socket. Figure S. Orienting E2 Chip InSWUng the ECPU Bomrd 1. install the new ECPU board in the console following the steps outlined in Figure 6. i , , i U33 It ommommom If gt 2 Pull up wtth fingers on ( slides to close lifting Ufting clamps clamps against ends of Int chip and lifting Willing hooks 7 d hooks under ends of chip 4 Continuing to apply pressure with fingers. gently lift the tool straight up until the chip pins are clear of the socket xuinue to pun up at fingers until 1p Is lifted up sinst bottom tool. Figure 4. Removing the EEPROM Chip from the ECPU Board --jj ------L----- U -----!a.--. ---1,7Tthm'MnTnm M MI'T nM 'MM '�J u' ------------ U13 i----! Notch w � I (Painted r r on board) 17 indented f r U32 F - 1 i 1 1 , samlt3rct9 r :, (Onch!p) ---- t r U12 t , I r -_--� Y2 Check to see that chip pins are aligned and not bent. Orient clip so that the small indented semicircle on the top of the chip is on the same end as the small notch painted on the board above the socket (in this example on the top) . Carefully align the chip pins over the socket how and gently push the cls down until all the pins are in the socket holes. Then putt dawn frallyy and evenly on the chip lentil it is down against the socket. Check to see that each of the pins is in is socket. Figure S. Orienting E2 Chip InSWUng the ECPU Bomrd 1. install the new ECPU board in the console following the steps outlined in Figure 6. i , , i U33 It ommommom If