Laserfiche WebLink
11 <br />Diversified Products Inc. has subjected its materials and products to extensive <br />testing including Underwriters Laboratories. <br />✓ Each product line and grouping has its own approval challenges. <br />Approvals in general reside at the local regulatory level. Each regulatory agency has <br />a threshold as to what must be done by a manufacturer to receive their blessing for <br />installation within their jurisdiction. <br />In most states of the USA approval is vested at the state level. Some states allow <br />the local counties or cities to adopt their own constraints before they will allow a <br />product to be installed. <br />✓ Where a State, County or City has their own approval process, that data is contained on our <br />website. <br />✓ You may visit our website www.dpm-llc.com and check out our "Approvals" section to find <br />information that deals with each state and local regulatory agency and their requirements. <br />We have provided in this reference manual some of the relevant data for your <br />initial review and approval of our products. <br />✓ Third party Testing Approvals: <br />• DPM has had all of its products reviewed by a third party RH Lee and Associates in 2003. <br />Those approvals have been reproduced and attached for your review. <br />✓ UL Approvals: <br />• DPM sought and received a listing for its penetration fittings in 1996 and again in 2004. <br />The 2004 UL report is reproduced hereinafter for your review. Note that the approval <br />for our split repair products was dated in 2006, the tests were performed in 2004. UL <br />just did not get around to including the products in letter form until 2006. <br />✓ Manufacturers Approvals: <br />• Some agencies require a manufacturers approval for a product to be repaired. <br />• When it comes to penetration fittings, some manufacturers have been out of business <br />and such approvals may be impossible to obtain. <br />• When it comes to Liners for spill containers some manufacturers are not cooperative as <br />they perceive the lining of their product to be a conflict with their current sales <br />objectives. <br />• We have included a manufacturers approvals section for your consideration. <br />Diversified Products Manufacturing Inc. Approvals for Tech Manual Rev 2 Page 1 of 13 <br />