COMPLIANCE INFO_2012-2018 - Laserfiche WebLink

Home Browse Search

File MH28727 Vol 1 EGVV Page 1 Issued: 2012-10-09 Listing Mark Data Page (LMDP) (FILE IMMEDIATELY AFTER AUTHORIZATION PAGE) LISTING MARK The Listing Mark consists of four elements placed in close proximity and shall appear on Listed products only. Minimum size is not specified, as long as the listing Mark is legible. The following is suggested. XXXX = the control number assigned by UL, 8JA7 The minimum height of a registered trademark symbol shall be 3/64 of an inch. When the overall diameter of the UL Mark is less than 3/8 0£ an inch, the trademark symbol may be omitted if it is not legible to the naked eye. The product identity is: "FLAMMABLE AND COMBUSTIBLE LIQUID TANK ACCESSORY". The product identity may be omitted if the Mark is directly and permanently applied the product by stamping, molding, ink stamping, silk screening or similar process. The product identity may appear elsewhere on the product if the three elements are part of the nameplate which includes the rating or the catalog or model designation. Separable Listing Mark (not part of the nameplate and in the form of decals, stickers or labels) will always include the four elements. The manufacturer may reproduce the Mark or obtain it from a UL authorized supplier THIS PAGE IS TO BE REVISED BY FUS DEPARTMENT ONLY File MH28727 Page T5-1 of 2 Issued: 2012-10-09 TEST RECORD NO. 5 SAMPLES: Samples of the Models RFSF1.4 (non split) and IRF L3.5P (split ) sump penetration fittings fabricated of "Fortex 92 "and the split fitting bonded with FastFuse glue and Filled with Urethane Sealant were submitted by the manufacturer. The sump penetration fittings were installed by the manufacturer to the bottom of 5 gallon polyethylene buckets. Short lengths of plugged pipe were band clamped to each fitting and the fittings were filled with Urethane Sealant. The SBL3.5 split repair fittings were bonded with FastFuse Glue. Each bucket had provision for filling, sealing and pressurizing. GENERAL: The test results relate only to the items tested. The following tests were conducted with the results indicated. SIMULATED USE RESISTANCE TO FLUIDS TEST: METHOD One container as described above was filled with each of the fluids Listed below such that the fittings inside the sump were completely covered with the fluids. The samples and fluids were maintained at a temperature of 100°F throughout the exposure. Following 30 days in this condition, the containers were subjected to an internal pressure of 3 psig (based on a maximum sump depth of 7 ft.) while the samples were examined for evidence of leakage. Premium Leaded Gas 50% Methanol/50% ASTM Reference Fuel C Regular Unleaded Gas 50% Ethanol/50% ASTM Reference Fuel C ASTM Reference Oil 2 15% Methanol/85°. ASTM Reference Fuel C ASTM Reference Fuel A 15% Ethanol/85% ASTM Reference Fuel C ASTM Reference Fuel C 100% Ethanol Toluene 10% Ethanol/90% ASTM Reference Fuel C 100% Methanol 30% Ethanol/70% ASTM Reference Fuel C 70oC Air Oven RESULTS There was no evidence of leakage.