Laserfiche WebLink
Monitoring System Certification <br /> D. Results of Testing/Servicing <br /> Software Version Installed: <br /> Complete the following checklist: <br /> Yes ❑ No* Is the audible alarm operational'? <br /> Yes ❑ No* Is the visual alarm opera ional? <br /> Yes ❑ No* Were all sensors visually inspected, functionally tested,and confirmed operational'? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation'? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modern) <br /> N/A operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected'? If yes: which sensors initiate <br /> positive shut-down'? (Check all that apply) Sump/Trench Sensors; Dispenser Containment Sensors. <br /> Did you confirm 2ositive shut-down due to leaks and sensor failure/disconnection? Yes ❑ No. <br /> Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warming device (i.e. no <br /> ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fillpoint(s)and o erating properly'? If so,at what percent of tank capacity does the alarm trigger'? Fb% <br /> ❑ Yes* )S No Was any monitoring equipment replaced'? If yes, identify specific sensors, probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E, below. <br /> ❑ Yes* ,� No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that upplr) ❑ <br /> Product; ❑ Water. If yes,describe causes in Section E,below. <br /> Yes ❑ No* I Was monitoring system set-up reviewed to ensure proper settings'?Attach set up reports, if applicable <br /> Yes ig equipment oerational per manufacturer's specifications'? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> UN-036-2/4 Page 2 of 3 Rev.06/04/01 <br /> www.unidocs.org <br />