COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

M A T E, R l A I S A F E T Y D A T A S H E D T E300-BKII 03/18/2002 Page: 3 SECTION VI REACTIVITY DATA STABILITY: Stable. HAZARDOUS POLYMERIZATION: Will. not occur. CONDITIONS TO .VOID: Extremely high temperatures, poor ventilation and excessive aging. INCOMPATIBILITY (MATERIALS TO AVOID) : Avoid contact with strong oxidizing agents. HAZARDOUS DECOMPOSITION OR BY PRODUCTS: Thermal decomposition may produce carbon dioxide and/or carbon monoxide. SECTION VII SPILL AND LEAK PROCEDURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Follow instructions in Sections IV, V, VI, VII and VIII to prevent health hazards. Eliminate all sources of ignition. Sweep up and prevent dust cloud from forming. Prevent from spreading to ground water. Use non-sparking shovels to scoop up. Place material in recovery container for disposal. WASTE DISPOSAL METHOD: Powder may be classified as a non-hazardous material . However, material should first be tested in accordance with EPA for STLC and TTLC requirements. Dispose of in accordance with local, state and federal regulations. SECTION VIII SAFE HANDLING AND USE INFORMATION RESPIRATORY PROTECTION: If TLV of the product or any component is exceeded, a NIOSH approved dust respirator is advised in absence of environmental control. OSHA Regulations also permit other NIOSH dust respirators under specified conditions. (See your Safety Equipment Supplier) Engineering or administrative controls should be implemented to reduce exposure. VENTILATION: Provide sufficient "UL" approved mechanical (General and/or Local exhaust) ventilation to control dust. PROTECTIVE GLOVES: Gloves are recommended to prevent exposure to powder. EYE PROTECTION: See your supervisor for proper eye protection. OTHER PROTECTIVE EQUIPMENT: Prevent repeated or prolonged skin contact, wear impervious clothing and work shoes. HYGIENIC PRACTICES: Remove and wash soiled clothing before reuse. Wash hands before eating or smoking. Key: BKAI-8300