COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

ARkEMA SAFETY DATA SHEET RILSAN® 5956 GREY RDP 15-10 ES Immediately flush eye(s)with plenty of water. Obtain medical treatment for thermal burns. Ingestion: If swallowed, DO NOT induce vomiting.Gel medical attention. Never give anything by mouth to an unconscious person. 5. FIREFIGHTING MEASURES Extinguishing media(suitable): Water spray, Carbon dioxide(CO2), Foam Extinguishing media(unsuitable): High volume water jet Protective equipment: Fire fighters and others who may be exposed to products of combustion should wear full fire fighting turn out gear (full Bunker Gear)and self-contained breathing apparatus(pressure demand/NIOSH approved or equivalent). Further firefighting advice: Do not use a solid stream of water. A solid stream of water can cause a dust explosion. Do not allow run-off from fire fighting to enter drains or water courses. Fire fighting equipment should be thoroughly decontaminated after use. Fire and explosion hazards: Dust clouds generated during handling and/or storage can form explosive mixtures with air. Dust explosion characteristics vary with the particle size, particle shape, moisture content,contaminants,and other variables. Note: Check that all equipment is properly grounded and installed to satisfy electrical classification requirements.As with any dry material, pouring this material or allowing it to free-fall or to be conveyed through chutes or pipes can accumulate and generate electrostatic sparks,potentially causing ignition of the material itself, or of any flammable materials which may come into contact with the material or its container. When burned,the following hazardous products of combustion can occur: Carbon oxides Hazardous organic compounds Hydrogen cyanide(hydrocyanic acid) (traces) 6.ACCIDENTAL RELEASE MEASURES In case of spill or leak: Prevent further leakage or spillage if you can do so without risk. Evacuate area of all unnecessary personnel. Ventilate the area. Eliminate all ignition sources.Avoid dust formation and dispersal of dust in the air.Wet down (dampen)the spilled material with water.Sweep or scoop up using non-sparking tools and place into suitable properly labeled containers for prompt disposal.The sweepings should be wetted down further with water.Avoid dispersal of spilled material and runoff and contact with soil,waterways,drains and sewers. Implement workplace practices such that dusts are not allowed to accumulate on surfaces,as these may form an explosive mixture if they are released into the atmosphere in sufficient concentration. Consult a regulatory specialist to determine appropriate state or local reporting requirements,for assistance in waste characterization and/or hazardous waste disposal and other requirements listed in pertinent environmental permits. Product code:A09469 Version 1.0 Issued on: 05/15P2015 Page:4/16 Quick-FDS(17303-32698-27051-016798)-2015-05-16-09:04:58