COMPLIANCE INFO_1993-2006 - Laserfiche WebLink

Home Browse Search

Lodi Memorial Hospital Facilities Management Environmental Services WASTE STERILIZER L-8440-050 2. Stand away from the unit to allow the safe release of any steam that may be inside the unit and lift the locking latch at the top. 3. Turn the arrow knob on the unit handle to the up position. Move the handle up and down until the door releases. 4. Open door, fasten the door open with the hook attached to the back wall to prevent the door from closing on you. C. Holding drawer. 1 To open drawer, place the rails down, check for proper alignment. When aligned, pull the drawer out. 2. To close, push the drawer back into the unit, lift rails, unlock door from the wall. D. When filling the sterilizing unit, the drawer must not be filled beyond 75% maximum capacity for processing of each load. Never overload the drawerl 1 The bags must be closed securely with a twister r tied into a knot before placement inside the unit. 2. The contents of each bag will not exceed 50% fluid as a total volume. E. Closing the unit door. 1. Turn the arrow knob on the autoclave handle to the down position. 2. Move the handle up and down until the door is closed well. Do not force closed with strength. 3. When initially closing the door, place your hand on the door handle and push lightly. 4. When closed, close the locking lever at the top. F. To activate the processing cycle, place the key into the switch and turn it to start. The key will automatically return to the start position. Remove the key from the switch and return it to the janitors room immediately. G. Emergency stop button is located near the switch is a RED button for use to stop the cycle in emergency situations only. V. REMOVAL OF STERILIZED WASTE FOR COMPACTION/DISPOSAL A. Obtain keys for unit from the basement janitors room. B. Do not attempt to open the door of unit unless the pressure gauge has no reading indicated. Always check the gauge first to make sure it is at "0" (zero). I Check the graph to assure the load has processed at the right temperature and for the proper length of time. 2. Open the door to the graph chart and record the date, time, and initials prior to unloading the processed load. This is required for each time the unit is emptied. 3. Unlock the padlock and move the chain out of the locked position. Do not remove lock and chain away from the unit. 4. Stand away from the unit to allow the safe release of any steam that may be inside and lift the locking latch at the top. 5. Turn the arrow knob on the unit handle to the up position. Move the handle up and down until the door release.