ARCHIVED REPORTS_2012_2 - Laserfiche WebLink

Home Browse Search

APPENDIX D STATISTICAL METHODS TO DETERMINE CONCENTRATION LIMITS Tolerance Limit Methodologies The purpose of a tolerance interval approach is to define a concentration range from background well data, within which a large proportion of the monitoring observations should fall with a high probability. The proportion of the population included is referred to as the coverage. The probability with which the tolerance interval includes the proportion of the population is referred to as the tolerance coefficient. Consistent with USEPA and state recommendations, Sanitas (computer program utilized)uses a 95 percent coverage and 95 percent tolerance coefficient. The upper 95 percent tolerance limit will contain at least 95 percent of the distribution of observations from background well data. The tolerance interval method is described in the following documents: -- Introduction to Statistical Quality Control,D.C. Montgomery. John Wiley Publishing,New York. 1985. -- Statistical Analysis of Groundwater Monitoring Data at RCRA Facilities, Interim Final Guidance Document,USEPA. USEPA/530-SW-89-026. February 1989. -- Statistical Analysis of Groundwater Monitoring Data at RCRA Facilities, Addendum to Interim Final Guidance, USEPA. USEPA/530-R-93-003. July 1992. Shaw uses Groundwater Statistical Analysis System (GSAS, now referred to as Sanitas)to calculate tolerance limits for San Joaquin County Landfills. Sanitas is a statistical software program developed by Intelligent Decision Technologies, Ltd. (IDT). It is specifically designed to evaluate water quality monitoring data for landfills. Sanitas performs all pre- and post- analysis tests required so that the data do not violate size and distribution assumptions of the relevant statistical analysis. Within Sanitas,the EPA Standards are used to evaluate all data. Parametric Tolerance Limit When conducting the tolerance interval method, Sanitas automatically evaluates the distribution of the data. Within Sanitas, Shaw selects the Coefficient of Variation test for normality to be applied. Sanitas applies the parametric tolerance limit test when the background data set is found to have less than 50 percent non-detects and the background data have a normal or transformed normal distribution. If greater than 15 percent but less than 50 percent of the background data set consist of non-detect values, the mean and standard deviation of the data set are adjusted using the Aitchison's Method. The tolerance limit is then calculated using the adjusted values. Foothill Sanitary Landfill D-1 Department of Public Works/Solid Waste 2"d Semester and Annual 2013 Groundwater Monitoring County of San Joaquin—January 31,2014