Laserfiche WebLink
ASBESTOS by TEM: METHOD 7402, Issue 2, dated 15 August 1994-Page 7 of 7 <br /> CALCULATIONS: <br /> 21. Calculate and report the fraction of optically visible asbestos fibers on the fitter, <br /> (fs -ft,)/(Fs - Fb). Apply this fraction to fiber counts obtained by PCM on the same filter or on other <br /> filters for which the TEM sample is representative. The final result is an asbestos fiber count. The <br /> type of asbestos present should also be reported. <br /> 22. As an integral part of the report, give the model and manufacturer of the TEM as well as the model <br /> and manufacturer of the EDX system. <br /> EVALUATION OF METHOD: <br /> The TEM method, using the direct count of asbestos fibers, has been shown to have a precision of <br /> 0.275 (s,) in an evaluation of mixed amosite and wollastonite fibers. The estimate of the asbestos <br /> fraction, however, had a precision of 0.11 (s �). When this fraction was applied to the PCM count, the <br /> overall precision of the combined analysis was 0.20[2]. <br /> REFERENCES: <br /> [1] Walton,W. H. "The Nature, Hazards, and Assessment of Occupational Exposure to Airborne <br /> Asbestos Dust: A Review," Ann. Occup. Hyg., 25, 115-247 (1982). <br /> [2] Taylor, D. G., P. A. Baron, S. A. Shulman and J_ W. Carter. "Identification and Counting of <br /> Asbestos Fibers," Am. Ind. Hyg. Assoc. J. 45(2), 84-88(1984). <br /> [3] Johnston,A. M., A. D. Jones, and J. H_ Vincent. 'The Influence of External Aerodynamic Factors <br /> on the Measurement of the Airborne Concentration of Asbestos Fibers by the Membrane Filter <br /> Method," Ann. Occup. HvQ_ 25, 309-316 (1982). <br /> [4] Zumwalde, R. O. and J. M_ Dement. Review and Evaluation of Analytical Methods for <br /> Environmental Studies of Fibrous Particulate Exposures, NIOSH Technical Information Bulletin <br /> #77-204 (1977). <br /> [5] Baron, P. A. and G. C. Pickford. "An Asbestos Sample Filter Clearing Procedure," AS I. L— Hvo., <br /> 1:169-171,199 (1986)- <br /> [6] LeGuen, J. M. and S. Galvin "Clearing and Mounting Techniques for the Evaluation of Asbestos <br /> Fibers by the Membrane Filter Method" Ann. Occup. Hyg. 24, 273-280 (1981)- <br /> [71 Yamate, G., S. A. Agarwal, and R. D. Gibbons. "Methodology for the Measurement of Airborne <br /> Asbestos by Electron Microscopy,"EPA Contract No. 68-02-3266 (in press). <br /> [8] Steel, E. B. and J. A. Small. "Accuracy of Transmission Electron Microcopy for the Analysis of <br /> Asbestos in Ambient Environments;' Anal. Chem., 57, 209-213 (1985). <br /> METHOD REVISED BY: <br /> Paul A. Baron, Ph.D.; NIOSH/DPSE. <br /> NIOSH Manual of Analytical Methods(NMAM),Fourth Edition, 8/15/94 <br />