Laserfiche WebLink
through DTSC and may be required to manifest any shipments of these ballasts and <br />capacitors. The hauler of these items may also be required to register as a hazardous <br />waste transporter with DTSC. There are some exceptions to the manifesting and <br />transporter registration requirements that may apply to some generators of PCB ballasts <br />and capacitors. For example, under section 25163(c) of the Health and Safety Code <br />(HSC), persons transporting small quantities (no greater than 5 gallons or 50 pounds) of <br />hazardous waste to a permitted facility are exempt from manifest and transporter <br />registration requirements when specified conditions are met. HSC section 25163.3 <br />provides a conditional exemption from manifest and transporter registration <br />requirements for persons consolidating hazardous wastes from remote locations at a <br />generator's site. <br />California DTSC treatment standards for PCB containing electrical components are: <br />1) Incineration in a DTSC approved incinerator with a PCB Destruction Removal <br />Efficiency of 99.9999%; or <br />2) Disposal in a hazardous waste landfill after placement in a lab pack. <br />Currently, the only landfill in California that can accept hazardous PCB wastes is the <br />Chemical Waste Management's facility at Kettleman Hills, California, (209) 386-9711. <br />There are currently no incinerators operating in California which meet the DTSC <br />destruction requirement. <br />For a further discussion on handling, treatment, and disposal of PCB wastes, refer to <br />the PCB Fact Sheet in appendix C. <br />4.0 Oils / Lubricants <br />Used oil includes ane spent lubricating fluids that have been removed from vehicles, <br />equipment, or machines. Used oil found within appliances include compressor oils <br />contained within refrigeration and air conditioning equipment and transmission oils <br />contained within clothes washers. <br />4.1 Lubricant Extraction Methods <br />The refrigerant within air conditioning and refrigeration equipment must be extracted <br />prior to draining the oil from the compressor or removing the compressor from the <br />appliance. If the refrigerant is not extracted, the removal of oil from the compressor or <br />the removal of the compressor from the appliance will cause the refrigerant to vent to <br />the atmosphere. Section 608 of the federal Clean Air Act (CAA) prohibits individuals <br />from knowingly venting ozone depleting compounds, used as refrigerants, into the <br />atmosphere while maintaining, servicing, repairing or disposing of air-conditioning or <br />refrigeration equipment. The US EPA is authorized to assess fines of up to $25,000 per <br />15 <br />