Laserfiche WebLink
AeroVent Standard <br /> ALWAYS wear appropriate personal protective equipment when operating the unit ! <br /> 5/ 16- 18 x 3/4" Bolt (4) • Plunger <br /> '/d' Flat Washers (4 ) Block Kit #7 Box should include these parts , <br /> 5 /16- 18 Locking Nuts (4) <br /> f8/e2F�`h <br /> 1 Lid Handle • AeroVent® unit with ground cable <br /> #5 • #3 -Operating Handle <br /> Safe2Filter tt it li • # 14-Safe2Filter <br /> # 14 • <br /> 5/ 16-vent riva 18 x 3/4" Bolt (4) <br /> �m /� <br /> ��- `~` • '/4" Flat Washers (4) <br /> 5/ 16- 18 Locking Nuts (4) <br /> #7-Plunger Block Kit (3 ) <br /> • Can Stop <br /> pp Operating : #5 -Lid Handle <br /> Can Stop Front Su o Handle #3 Owner' s Manual <br /> Foot <br /> ASSEMBLY <br /> 1 ) Install front support foot that was removed for shipping. Screw all the way in <br /> 2) Remove the 2" bung-fitting cap from an empty 30 or 55 gallon recovery <br /> drum . Insert the threaded nipple of the AeroVent® into the opening and <br /> turn the unit until hand tight. One adjusting foot should be located just _ <br /> inside the chime . The other should rest on top of the chime . <br /> 3 ) Turn the adjustable rear support foot clockwise until snug to the top of Vent i <br /> the drum. Adjust front support foot tight to chime after adjusting rear , <br /> foot. <br /> 4) Open lid and let it rest against back stop . Remove 2 screws from lid <br /> handle. Position handle on top of lid and install screws from underside <br /> and tighten screws . FIGURE 1 <br /> 5 ) Place the operating handle on the mounting post. Insert one 5/ 16- 18 x 1 " <br /> bolt through each handle and mounting post hole. Secure with one <br /> 5/ 1648 locking nut and washer on each bolt and snug nuts at this time . (Pic 1 ) <br /> 6) Place one of the Plunger Blocks into the hole on the closed lid assembly. <br /> Lower the handle and adjust the swivel foot so that it is centered in the <br /> plunger block. <br /> Completely tighten all nuts and bolts of the handle assembly to the <br /> mounting post at this time . (Pic 2) <br /> 7) Install can stop in slots at front of can tray . <br /> 8 ) Remove the 3 /4" bung fitting cap from top of the recovery drum and \ <br /> thread the Safe2Filter filter housing into place . Hand-tighten only ! <br /> 9) Attach the clamp end of the grounding cable to a suitable grounding FIGURE 2 <br /> source, such as a metal water pipe or grounding rod . <br /> Newstripe Inc ., 1700 Jasper St ., Unit F, Aurora, CO 80011 •I ' 800 .624 .6706 F 303 . 364. 7796 o Newstripe . com <br /> AeroVent ® Standard Manual / 4840 . 1117 <br />