Laserfiche WebLink
AeroVento Standard <br /> ALWAYS wear appropriate personal protective equipment when operating the unit ! <br /> COBALT POINT REPLACEMENT <br /> HELPFUL HINT : Leave the unit mounted on the drum to replace cobalt points . <br /> 1 . Open the lid and remove the left and right shrouds . <br /> 2 . Loosen the bottom clamp on the bellows . There is no need to <br /> loosen the top bellows clamp, unless the bellows are damaged and <br /> need replaced . <br /> 3 . Remove the trough liner can stop . Bellows may have to be <br /> gently pried off of lower bushings to rotate assembly up . Rotate <br /> the trough assembly upward and allow it to rest against the lid . <br /> 4 . Loosen the setscrew with a 3 /32" hex key and then replace the <br /> point . Tighten the setscrew against the new point . Do not use <br /> locktight on this setscrew . <br /> 5 . Re- assemble the unit in reverse order. <br /> l <br /> X01 ; <br /> SAFE2FILTER REPLACEMENT <br /> 1 ) Remove the filter lid from the element by grabbing the edge and pulling upwards (you can pull on the check <br /> valve to expose the edge . ) <br /> 2) Lift off the filter element from the base . <br /> 3 ) Install the new element onto the filter base . <br /> 4) Replace the filter lid by pressing it into the top of the element . <br /> 5 ) Dispose of the used filter element appropriately. <br /> Retain lid <br /> Safe <br /> - - Safe2flltee Change <br /> A . filter <br /> element <br /> Drum Vent Filter arum Veal FM <br /> WPRetain base <br /> Newstripe inc., 1700 Jasper St., Unit F, Aurora, C080011 T 800.624.6706 F 303 .364.7796 • Newstripe .com <br /> AeroVent® Standard Manual / 4840 . 1117 <br />