COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? (] ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, I ❑ ❑ functional ) tested , and confirmed o erational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with th ❑ ❑ro er o eration? Was monitoring system set-up reviewed to ensure proper settings? ❑ ❑Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? C] ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically E ❑ ❑ disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? E ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) (] Sump [j] Under-dispenser containment If alarms are relayed to a remote monitoring station , is all communications equipment (e .g , modem) operational ? El ❑ ❑ For any answer of "M' above, describe in section IX how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN-TANK GAUGING TESTING (] Check this box if tank gauging is used only for inventory control . (Do not complete this section.) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ground E ❑ ❑ faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally tested , El ❑ ❑ and confirmed operational? Was accuracy of system's product level readings tested ? E ❑ ❑ Was accuracy of system's water level readings tested ? 0 ❑ ❑ Were all probes reinstalled properly? I] ❑ ❑ Were all items on the equipment manufacturer's maintenance checklist completed ? 0 ❑ ❑ For any answer of "M' above, describe in section XI how and when these deficiencies were or will be corrected. XI . COMMENTS Y = Yes$ N = No, NA = Not Applicable