COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

PREVENTATIVE MAINTENANCE from defects in materials and workmanship for a Annually, inspect the flapper in the 71 SO to see that period of one year from the date of manufacture by it is open by looking down the drop tube opening. OPW(ECO products two years from date of Test the 71 SO drop tube seals with CARB manufacture.) Proof of purchase may be required. procedure TP-201.1 D. If the drop tube seal passes As the exclusive remedy under this limited warranty, testing, no further maintenance is required. If the OPW, will at its sole discretion, repair, replace, or drop tube fails testing, replace the drop tube seal issue credit for future orders for any product that with OPW P/N: H 11931 M for 4" Tubes. Re-test the may prove defective within the one year date of 71 SO drop tube with CARB procedure TP-201.1 D. manufacture period (repairs, replacements, or The lower tube o-ring seal OPW P/N: H14840M can credits may be subject to prorated warranty for also be replaced. If this does not correct the leak remainder of the original warranty period, complete the 71 SO needs to be replaced. proper warranty claim documentation required.) This warranty shall not apply to any product that has CAUTION: Do not insert any foreign object into been altered in any way, which has been repaired by drop tube if flapper is in the closed position. For any party other than a service representative example a tank level measuring stick. This will authorized by OPW, or when failure is due to damage the valve and void the Warranty. misuse, or improper installation or maintenance. ALWAYS check flapper location before OPW shall have no liability whatsoever for special, "sticking" the tank. If flapper is in the closed incidental or consequential damages to any party, position the tank is either over filled and you and shall have no liability for the cost of labor, need to wait until the liquid level goes down or freight, excavation, clean up, downtime, removal, the 71 SO is damaged and needs to be replaced. reinstallation, loss of profit, or any other cost or charges. 71 SO Performance Specifications: For any product certified to California 2001 This Overfill Prevention Valve has been standards, OPW warrants that product sold by it are manufactured and tested to, and met, the following free from defects in material and workmanship for a California specifications. Performance Requirement: period of one year from date of manufacture or one Leak rate to be less than or equal to 0.17 CFH @ year from date of registration of installation not to 2.0"W.C. exceed 15 months from date of manufacture by OPW. Torque Specification: THIS WARRANTY IS IN LIEU OF ALL OTHER Taptite Screws, #10-24 thread cutting, 20 in-lbs WARRANTIES, EXPRESS OR IMPLIED, AND minimum to 35 in-lbs maximum. SPECIFICALLY THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A Important: Leave these installation instructions and PARTICULAR PURPOSE. THERE ARE NO maintenance procedures with the station operator. WARRANTIES, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. Notice: OPW products must be used in compliance with applicable federal, state, and local laws and <Do FO regulations. Product selection should be based on _ physical specifications and limitations and A DOVER ' OMPANY compatibility with the environment and material to be handled. All illustrations and specifications in this P.O. Box 405003 * Cincinnati, Ohio 45240-5002 literature are based on the latest production 1-800-422-2525 Domestically information available at the time of publication. 513-870-3315 Internationally Prices, materials, and specification are subject to www.opw-fc.com change at any time, and models may be Copyright, 2007- OPW Fueling Components Inc., discontinued at any time, in either case, without Cincinnati, OH notice or obligation. Printed in U.S.A. p/n H15524PA—Rev. F 9/07 Standard Product Warranty OPW warrants that products sold by it are free 74