Laserfiche WebLink
k Quality Assurance/Quality Control Plan Page 4 <br /> 5.3 DELIVERY OF SAMPLES TO LABORATORY <br /> Samples will be delivered to the laboratory on a daily basis. Samples will be refrigerated to <br /> approximately 4°C for shipping Shipping containers will be sealed with security tape to assure <br /> sample integrity during shipping Delivered samples will be accompanied by a chain-of-custody <br /> record The laboratory shall note on the chain-of-custody that samples were properly preserved <br /> and security tape was intact upon arrival <br /> E <br /> 6.0 SAMPLING AND DRILLING EQUIPMENT DECONTAMINATION <br /> f <br /> All equipment used for drilling and sampling will be decontaminated prior to use All equipment <br /> used for collection of more than one sample, such as bailers and spoons, will be decontaminated <br /> between each use to prevent cross contamination between samples Drilling equipment will be <br /> decontaminated prior to commencing drilling at each hole Well construction materials will be <br /> cleaned as necessary, prior to installation <br /> Equipment and well material decontamination will be conducted on an impermeable surface and <br /> all decontamination effluent will be contained All surfaces of the equipment will be thoroughly <br /> decontaminated using a steam cleaner The equipment will be placed on a drying rack for air <br /> G <br /> drying The decontamination water will be stored in containers certified for hazardous materials <br /> storage and disposed of in an approved manner <br /> � I <br /> Sample equipment to be used for pesticides and organic analysis will be washed in a <br /> ` nonphosphate detergent (Alconox or equivalent) and rinsed with tap water, followed by <br /> deaonized water and finally with acetone If the equipment is for metals analysis, the initial rinse <br /> will be conducted with 0 1 M nitric acid followed by tap water and deionized water <br /> 7.0 FIELD EQUIPMENT CALIBRATION AND MAINTENANCE <br /> The following measuring equipment may be used during the Remedial Investigation Equipment <br /> iis grouped by field activity Calibration procedures and frequency are listed for each piece <br />