Laserfiche WebLink
Item # 207 <br /> Assembling Probe Components Assembling Floats onto Probe Shaft <br /> Assembling Floats onto Probe Shaft <br /> The Product floats,Water Floats (if ordered), and Boots from Probe Installation Kits are assembled on the probe <br /> shafts in the exact sequence and orientation shown in Figure 9. <br /> IMPORTANT! Failure to push the boot as far as possible onto the probe shaft could cause the boot and float(s) to <br /> fall into the tank.The boot must be pushed on until it"locks"on the probe shaft.Also, water floats must be <br /> installed, if ordered,for the probe to operate correctly. <br /> Handle the probe carefully. Striking or dropping the probe will result in loss of calibration and could cause <br /> permanent damage. <br /> 4-Inch Floats 3-Inch Floats 2-Inch Floats <br /> — -OR- - — <br /> 1 r�Product float- I i �r Product float- Product float- <br /> slide on probe I slide on probe I slide on probe <br /> shaft first shaft first. i I shaft first. <br /> I I I I I <br /> I \ <br /> I I I <br /> Up t i <br /> I -Water float- I Water float- Water float- <br /> A (Optional) I ♦ (Optional) A (Optional) <br /> slide on probe I slideon probe slide on probe <br /> I shaft second I shaft second. shaft second. <br /> I I <br /> I I I I I I <br /> I I I I I <br /> I <br /> I <br /> Bottom of Boot-slide on Boot-slide on Boot-slide on <br /> probe shaft I A probe shaft last f A probe shaft last probe shaft last <br /> y I <br /> I I 744-5.ePs <br /> I I <br /> Figure 9. Probe float installation <br /> 12 <br />