Laserfiche WebLink
Work Order# 388200 <br /> Fuel SerUices Site: 953 Tracy Fedex Ground <br /> 5655 Hood Way <br /> Phone: 1-800-215-4839 x2 FSR#: 9012 Franzen-Hill Corporation- Tracy, CA 95377 <br /> Tulare <br /> Fax: 1-305-629-4288 FSR FAX#: 775-329-3301 Phone: 209-839-2060 <br /> CUSTOMER <br /> Site: 953 Tracy Fedex Ground Problem Code: 2016 Notice Of Violation <br /> 5655 Hood Way <br /> Tracy, CA 95377 <br /> Dispatched Date 8/1/2018 <br /> Dispatched Time 2:24:50PM CT <br /> Phone: 209-839-2060 Priority P3 0-24 Hours <br /> Requested By: NOV <br /> Ryder FS INFORMATION <br /> Dispatched By: Ryder FS <br /> Questions Call: 1-800-215-4839 x2 <br /> PROBLEM DESCRIPTION <br /> COMPLIANCE ; Notice Of Violation:>Please address the following issues: <br /> 1)The bio-diesel(699)spill bucket has a tear in the side of it and fails. Spill bucket replacement needed. Quote will be <br /> needed-please provide <br /> 2)This is a VPH site and communication could not be confirmed on the vent line secondary, bio-diesel/DEF product line <br /> secondary or on the line secondary at dispenser#5.There is communication at the end of this main line but not at#5. <br /> 3) Small amount of brine found in BioDiesel blending sump-investigate for potential cause, but repairs may be required by <br /> others depending on what is found-advise RFS of findings in this sump prior to making any repairs <br /> 4) Liquid and absorbent pad found in DSL STP 2. Investigate sump and determine if there is water intrusion issue. Identify <br /> any corrections that may be required in the event repairs exceed$1 K a quote will be needed <br /> If TcqJQK NWKSxceed$1 K, please stop and call RFS-a quote and subsequent approval will be required to proceed with <br /> repairs exceeding 1 K. <br /> Technician must call Ryder FS (800-215-4839 x2)upon arrival and prior to leaving the location. Failure to obtain their check <br /> in and check out codes may result in delays for processing invoices. <br /> Approval must be obtained from Ryder FS prior to replacing any parts. If a sensor or probe is replaced, technician must <br /> test component for operability and submit a copy of the alarm history from the gauge showing all alarms were obtained with <br /> invoice. <br /> Technicians placing dispensers in stand-alone mode during the course of their work must return them to normal operating <br /> condition prior to leaving the location. <br /> If it becomes necessary to remove liquid from a containment sump to complete this work request,your technician must <br /> follow these steps: <br /> 1. Call Ryder FS and report type and amount of liquid found. <br /> 2.All liquid removed must be disposed of using 1 of the following options: <br /> a. pumped into oil/water separator <br /> Page 2 of 3 <br />