COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM ( Page a of 6) VI11 . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? n ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, NX1 ❑ ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with 0 ❑ ❑ their proper operation? Was monitoring system set-up reviewed to ensure proper settings? ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? ❑X ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? QX ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electricallyNX 0] ❑ disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? R ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) FXSump QUnder-Dispenser Containment If alarms are relayed to a remote monitoring station , is all communications equipment (e . g . , modem) operational? ❑ EE3 J Q For any answer of "N" above, describe in Section IX how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN -TANK GAUGING TESTING ❑ Check this box if tank gauging is used only for inventory control. (Do not complete this section.) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak .detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing forFX El El round faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionallyFX ❑ tested , and confirmed operational?.. ❑ 1:1Was accuracy of system's product level readings tested ? Was accuracy of system's water level readings tested? ❑ 1:1 nX El Were all probes reinstalled properly? ❑ Were all items on the equipment manufacturer's maintenance checklist completed? 0 F1 F] For any answer of "N" above, describe in Section X1 how and when these deficiencies were or will be corrected. XI . COMMENTS Y = Yes, N = No, NA = Not Applicable