Laserfiche WebLink
UNDERGROUND STORAGE TANK <br /> MONITORING SYSTEM CERTIFICATION FORM (Page 4 of 6) <br /> VI11 . MONITORING SYSTEM AND PROGRAMMING <br /> This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y IN NA <br /> Are the visual and audible alarms operational? R F <br /> Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, <br /> functionally tested , and confirmed operational? <br /> Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with <br /> their proper operation? <br /> Was monitoring system set-up reviewed to ensure proper settings ? R <br /> Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? ❑X1:1 El <br /> Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? Q Ej ❑ <br /> Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically ❑X <br /> disconnected ? El El <br /> Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? <br /> Which sensors initiate positive shut down? (Check all that apply.) OX Sump OX Under-Dispenser Containment FX1 El El <br /> If alarms are relayed to a remote monitoring station, is all communications equipment (e. g . , modem) operational? 19 1:1 El <br /> For any answer of "N" above, describe in Section IX how and when these deficiencies were or will be corrected. <br /> IX. COMMENTS <br /> X. IN -TANK GAUGING TESTING <br /> ❑X Check this box if tank gauging is used only for inventory control. (Do not complete this section.) <br /> ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA <br /> This section must be completed if in-tank gauging is used to perform leak detection monitoring, <br /> Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for <br /> round faults ? <br /> Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally <br /> tested , and confirmed operational? 1:1 El <br /> Was accuracy of system's product level readings tested? 0 <br /> Was accuracy of system' s water level readings tested ? Q <br /> Were all probes reinstalled properly? El R El <br /> Were all items on the equipment manufacturer's maintenance checklist completed? El <br /> For any answer of "N" above, describe in Section XI how and when these deficiencies were or will be corrected. <br /> XIS COMMENTS <br /> Y = Yes, N = No, NA = Not Applicable <br />