Laserfiche WebLink
2. Connecting lines may be run through access in back of the unit or extend down through a <br /> counter cut out. <br /> 3. The counter must support the weight of the dispenser, ice, and possibly an ice maker. Total <br /> weight may exceed 800 lbs (363.6 kg). <br /> B. Unit may be installed directly on the countertop or on legs supplied with the unit. If installed <br /> directly on the counter, the unit must be sealed to the countertop. If an ice maker is to be <br /> mounted on top of dispenser, do not install dispenser on legs. <br /> NOTE <br /> Water pipe connections and fixtures directly connected to a potable water supply must all be <br /> sized, installed, and maintained according to Federal, State, and Local laws. <br /> The water supply must be protected by means of an air gap, a backflow prevention device <br /> (located upstream of the CO2 injection system) or another approved method to comply with <br /> NSF standards. A backflow prevention device must comply with ASSE and local standards. <br /> It is the responsibility of the installer to ensure compliance. <br /> SUFFICIENT CLEARANCE FOR NOTE: <br /> FILLING MANUALLY WITH ICE, Please refer to specific icemaker <br /> WHEN ICE MAKER NOT USED model for proper air intake%Xhaust <br /> o�04 <br /> ventilation with Lancer units. <br /> E <br /> NOTE: 22 Inch wide unit is <br /> M 9 3/4"(248 Mm) displayed in this <br /> DISPENSE HEIGHT illustration. <br /> t <br /> �— 30 1/2"(775 Mm) —► <br /> 1 <br /> MINIMUM of 6"(152 mm) MINIMUM of 6"(152 mm) <br /> clearance above ice maker clearance above ice maker <br /> 9'P J� e e e PSP <br /> �a <br /> AUT p>P e e e <br /> �JZ Iiq e e e <br /> 0 <br /> e e e 9 <br /> E <br /> e e R�N <br /> L2 U <br /> r C <br /> N U E (O N <br /> U C E U <br /> vICE M <br /> sH U U <br /> E f ami Z <br /> E E 2 <br /> v LAS <br /> 04 <br /> L2 <br /> 22"(559 mm)—►I 30 1/2"(775 mm) <br /> Figure 1 <br /> C. Location must insure sufficient clearance on sides, top and back of unit is provided for <br /> ventilation and air circulation (see Figure 1). <br /> D. Additionally, if an ice maker is not top mounted on the unit, sufficient clearance should be <br /> provided [a minimum of 16 inches (40.6 cm) is recommended] to allow filling the unit with ice <br /> 2 <br />